Investigation on picosecond laser ablation of dental material using FIB/SEM techniques
نویسندگان
چکیده
منابع مشابه
Study of laser ablation using nano-second laser pulses
In this paper, the laser ablation process based on the irradiation of nanosecond pulsed lasers on a copper target surface in the presence of Helium gas is studied. The dynamical behaviors of the generated plasma in the helium gas and evaporated copper at the atmospheric pressure are examined using a laser pulse, laser wavelength of and intensity of 7×1010W/cm2. A one-dimensional thermal model ...
متن کاملSub-picosecond UV laser ablation of metals
Laser ablation of Nickel, Copper, Molybdenum, Indium, Tungsten and Gold by short ultraviolet laser pulses (0.5 ps, 248 nm) in vacuum is reported for the first time. For Nickel and Indium, ablation is also studied in air to demonstrate the influence of the ambient atmosphere. Metal ablation in air is significantly less efficient than in vacuum due to redeposition of ablated material. The ablatio...
متن کاملIn situ photography of picosecond laser ablation of nickel
This work experimentally investigated the time evolution of nickel ablation induced by high-energy picosecond laser pulses. A Nd:YAG laser with a 25 ps pulsewidth was used to perform a pump–probe microphotography experiment. The fundamental and second harmonic wavelengths were used for the pump and probe beams, respectively. The probe beam was delayed in time with respect to the pump beam and w...
متن کاملPicosecond Laser Processing – Material Removal Rates of Metals
A picosecond laser has been used to establish the material removal rate of metals. Varied processing parameters include laser power, pulse frequency and scanning velocity. The laser beam was manipulated using a galvanometric scan head with a 100 mm focusing optic. Maximum power of the laser in the IR was 2 W and 700 mW in the UV. Scanning velocities were varied between 100 to 800 mm/s. Material...
متن کاملPicosecond Laser Processing – Material Removal Rates of Plastics
A picosecond UV laser has been used to establish the material removal rate of plastics. Varied processing parameters include laser power, pulse frequency and scanning velocity. The wave length of the laser used was 355 nm. Scanning velocity varied between 100 to 800 mm/s and repetition frequency between 10 to 500 kHz. Materials for the experiments were generally used plastics, which were availa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Indian Journal of Science and Technology
سال: 2010
ISSN: 0974-6846
DOI: 10.17485/ijst/2010/v3i2.25