Investigation on pitting resistance of Sn-containing ferritic stainless steel with solution simulation method
نویسندگان
چکیده
Abstract In this study, Sn 2+ solution simulation method is used to investigate the effect of on pitting corrosion behavior tin-containing ferritic stainless steel 430LX. It found that correlation between E pit and [Sn ] opposite critical potential temperature (CPT) ]. After potentiostatic polarization at a specific potential, correlations become same. The CPT experiment after series steps proves exhibits positive influence only when pH within certain range. All complicated phenomena can be explained by under-potential deposition mechanism. SnO 2 passivation film enhances resistance produced occurs.
منابع مشابه
External corrosion resistance of steel and ferritic stainless steel exhaust systems
The exhaust system has a number of requirements to fulfil. The major ones are to reduce the noise level created by the engine, to channel the waste gases out the rear of the automobile, to minimize the reduction in engine performance, and to have an acceptable service life and cost1. The exhaust system is divided into two main parts, the hot end and the cold end. The components comprising the h...
متن کاملAn Investigation on Corrosion and Stress Corrosion Cracking initiation of a Ferritic Stainless Steel in a Tertiary Amine Solution
The present study focused on stress corrosion cracking (SCC) and corrosion behavior of ferritic stainless steel (grade 430) in activated methyl diethanolamine (aMDEA) solution, which is classified as a tertiary amine. In this regard, cyclic polarization and U-bend tests were performed in CO2 loaded aMDEA with different concentrations at 25 and 70 °C to observe corrosion behavior and ...
متن کاملElectrochemical and passivation behavior investigation of ferritic stainless steel in simulated concrete pore media
The applications of stainless steel are one of the most reliable solutions in concrete structures to reduce chloride-induced corrosion problems and increase the structures service life, however, due to high prices of nickel, especially in many civil engineering projects, the austenitic stainless steel is replaced by the ferritic stainless steels. Compared with austenite stainless steel, the fer...
متن کاملIn situ observation of pitting of stainless steel by XAFS.
An in situ observation technique by XAFS (X-ray Absorption Fine Structures) has been developed for observation of metal corrosion. XAFS spectra were obtained with a special electrochemical cell to elucidate pitting: change of concentrations and structures of ions near the interface of solution and metal. It has been successfully shown that the concentrations of Cr and Br are linearly dependent ...
متن کاملPrecipitation sequence in niobium-alloyed ferritic stainless steel
Niobium is an important alloying element in the design of heat-resistant ferritic stainless steels for automotive exhaust systems. When in solid solution, it improves both the high temperature strength and the resistance to thermal fatigue. However, it also forms several kinds of precipitates during service. These reactions have been modelled, taking into account the multicomponent nature of th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials research express
سال: 2021
ISSN: ['2053-1591']
DOI: https://doi.org/10.1088/2053-1591/ac09bc