Investigation on Tensile Behaviour of Different Weld Joints through Taguchi Approach
نویسندگان
چکیده
Friction stir welding is a dependable method of joining metals and other materials. Relatively joint configuration-specific process parameters have not yet been tuned. This work concerned with the Taguchi orthogonal arrays to perform an analysis variance. In this study, FSW configurations AA6262-T6 Al alloy, such as butt, lap, T joints, were studied for optimization. An array welds was selected using method. After constructed, ultimate tensile strength each examined statistical The lack parameter optimization studies joints prompted research fill void. As result, arrangement must be optimised mechanical properties set developed.
منابع مشابه
Investigation on Tensile Strength of Friction Stir Welded Joints in PP/EPDM/Clay Nanocomposites
Polymer-based nanocomposites due to their advantages such as corrosion resistance,adequate mechanical properties and low cost are widely used in modern technologies. The increasing application of these nanocomposites, and hence their welding seems unavoidable. In this paper, a novel hottool in friction stir welding process is used for butt welding nanocomposite plates of 5 mm thick containing p...
متن کاملthe effect of functional/notional approach on the proficiency level of efl learners and its evaluation through functional test
in fact, this study focused on the following questions: 1. is there any difference between the effect of functional/notional approach and the structural approaches to language teaching on the proficiency test of efl learners? 2. can a rather innovative language test referred to as "functional test" ge devised so so to measure the proficiency test of efl learners, and thus be as much reliable an...
15 صفحه اولWeld Magnification Factor Approach in Cruciform Joints Considering Post Welding Cooling Medium and Weld Size
The objective of this research is to develop an experimental-theoretical analysis about the influence of the cooling medium and the geometry of the welding bead profile in fatigue life and the associated parameters with structural integrity of welded joints. A welded joint with cruciform geometry is considered using SMAW (Shielded Metal ArcWelding), plates in structural steel ASTM A36 HR of 8 m...
متن کاملInvestigation on Effect of Heat Input on the Microstructure and Mechanical Properties of Hadfield Steel Weld Joints in SMAW Process
In this investigation, the effect of heat input of SMAW process on the microstructure and mechanical properties of Hadfield steel weld joints was investigated. For this purpose, 4 annealed sheets with thickness 2 mm prepared from Hadfield steel and then welding applied by SMAW process with 6.75 and 11.25 kJ/mm heat input values. The evaluation of the microstructures of welding joints was condu...
متن کاملInvestigation on Effect of Heat Input on the Corrosion Behavior of Hadfield Steel Weld Joints in SMAW Process
In this investigation, the effect of heat input of SMAW process on the corrosion behavior of Hadfield steel weld joints was investigated. For this purpose, 4 annealed sheets with thickness 25 mm prepared from Hadfield steel and then welding applied by SMAW process with 6.75 and 11.25 kJ/mm heat input values. For corrosion behavior evaluation of base metal and weld metal areas, potentiodynamic p...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Materials Science and Engineering
سال: 2022
ISSN: ['1687-8434', '1687-8442']
DOI: https://doi.org/10.1155/2022/5258014