INVESTIGATION SOME PROPERTIES OF (ZN-NI-SIC) COMPOSITES COATING ON LOW CARBON STEEL
نویسندگان
چکیده
منابع مشابه
Failure Investigation of Hydrogen Blistering on Low-strength Carbon Steel
The current study assesses the root causes of hydrogen blisters on low strength carbon steel equipment. For this purpose, some experiments including hardness test, non-destructive test (NDT), metallography, and fractograpghy are conducted. The microstructure of two blisters is assessed by means of optical microscopy and scanning electron microscopy (SEM). The microstructural studies show that t...
متن کاملinvestigation of the electronic properties of carbon and iii-v nanotubes
boron nitride semiconducting zigzag swcnt, $b_{cb}$$n_{cn}$$c_{1-cb-cn}$, as a potential candidate for making nanoelectronic devices was examined. in contrast to the previous dft calculations, wherein just one boron and nitrogen doping configuration have been considered, here for the average over all possible configurations, density of states (dos) was calculated in terms of boron and nitrogen ...
15 صفحه اولInvestigation of Hardness, Morphology and Structural Analysis of NiCrBSi Composite Coating on Plain Carbon Steel
High velocity oxy-fuel (HVOF) is one of the emerging technologies among the thermal spraying techniques, for producing uniform and dense coatings, having high hardness and very low porosity. A NiCrBSi alloy coating was prepared with approximately 400µm thick, on the A516 steel by means of HVOF and was analyzed with regard to its detailed microstructures, phase formation, thickness, roughness an...
متن کاملMechanical Properties of Polypropylene Coating Containing Maleic Anhydride on Plain Carbon Steel
Using Electrostatic Spray Coating Technique, Polypropylene Powder (EPD 60R) was applied on carbon steel substrates at room temperature. In order to obtain a uniform coating, steel substrates with powder coatings were heated in a vacuum oven at various temperatures up to 250° C for various periods of time up to 45 min and a pressure of 200 mb. The coatings produced had thicknesses of around 470 ...
متن کاملMechanical Properties of Polypropylene Coating Containing Maleic Anhydride on Plain Carbon Steel
Using Electrostatic Spray Coating Technique, Polypropylene Powder (EPD 60R) was applied on carbon steel substrates at room temperature. In order to obtain a uniform coating, steel substrates with powder coatings were heated in a vacuum oven at various temperatures up to 250° C for various periods of time up to 45 min and a pressure of 200 mb. The coatings produced had thicknesses of around 470 ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: THE IRAQI JOURNAL FOR MECHANICAL AND MATERIALS ENGINEERING
سال: 2018
ISSN: 2313-3783,1819-2076
DOI: 10.32852/iqjfmme.vol18.iss2.100