IR Spectra of Solid State Reaction Products of TTF and Iodine
نویسندگان
چکیده
منابع مشابه
Synthesis & Characterization of CaB4O7 Powder by Solid-State Reaction
The synthesis of calcium tetraborate was investigated in a temperature ranging from 800℃ to 900℃ using the solid-state reaction method. The synthesis was done using ammonium tetraborate tetrahydrate as the source of boron. At temperatures of 800 ℃ and 880 ℃, the mixed phases from different compounds were formed. At the optimum temperature of 840℃, the mixed phase was only composed of meta and t...
متن کاملSynthesis and Processing of SnO2, CaSnO3 and Ca2SnO4 Nanopowders by Solid-State Reaction Technique
The nanopowders of SnO2, CaSnO3 and Ca2SnO4 in the size rang of 5-70 nm have been prepared using solid-state reaction technique. The technique is convenient and inexpensive in comparison to the conventional routes of compound prepared and processing where, many steps of mixing and annealing are i...
متن کاملReaction kinetics of solid-state cyclization of enalapril maleate investigated by isothermal FT-IR microscopic system.
To investigate the reaction kinetics of the solid-state degradation process of enalapril maleate, a Fourier transform infrared microspectroscope equipped with thermal analyzer (thermal FT-IR microscopic system) was used. The isothermal stability study was conducted at 120-130 degrees C for 1-2 h and changes in the three-dimensional plots of the IR spectra of enalapril maleate with respect to he...
متن کاملSolid State PIN Control Products
PIN diodes are fundamentally similar to standard diodes, but have an RF impedance that is determined by an externally supplied bias current. Their versatility makes them excellent building blocks in a wide variety of configurations within each product category, which allows diverse system requirements to be served. In short, the PIN diode enables all systems – from the least complex to the most...
متن کاملProperties and Medical Applications of Near-ir Solid-state Lasers
Cr-Tm-YAG, Cr-Tm-Ho-YAG, and Er-YAG lasers at 2.01 pm, 2.1 2pm, and 2.94 pm, resp., are compared regarding single-shot and high-repetition rate efficiency. The 2 pm lasers are intrinsically limited at higher operation temperatures, the Er-laser only shows thermal lensing. Th~n (3 mm) Tmand Ho-laser rods allow high repetition rates (30 Hz) and with increasing rod diameters pulse energies up to 1...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of the Chemical Society of Japan
سال: 1983
ISSN: 0009-2673,1348-0634
DOI: 10.1246/bcsj.56.2090