Jitter and Jitter Self-Compton processes for GRB High-energy Emission
نویسندگان
چکیده
منابع مشابه
Part 6 : Reference Clock Jitter and Data Jitter 1 Reference Clock Jitter and Data Jitter
Reference clock jitter sets the ultimate limit on the bit error ratio of a serial data system. The traditional techniques for quantifying jitter on clock signals don’t help system designers estimate the clock’s contribution to the total jitter defined at a bit error ratio. New techniques are being introduced to model how transmitters and receivers use reference clocks so that the system RJ and ...
متن کاملJitter in Self-Explanatory Simulation
Self-explanatory simulators combine qualitative and quantitative models to produce results that have both numerical behaviors and explicit qualitative causal structure. A problem that can arise in such simulations is jitter, a back and forth changing of a comparison that at first glance appears to be an unnatural artifact of the simulation. Jitter can be a serious problem because it slows simul...
متن کاملBIST for Jitter Measurement and Jitter Decomposition of CDR
This paper describes a Built-In-Self-Test (BIST) circuit that tests the relative timing jitter of NRZ data and recovered clock of PLL-based CDR. Using the jitter information, the bit error rate and peak to peak jitter can be estimated. This BIST circuit doesn’t need a high resolution and high accuracy delay line to achieve high accuracy measurement. It depends on calibration and curve fitting a...
متن کاملJitter Measurements
The TTCrx mezzanine card was installed on the Clock and Control Board [2] and connected to a TTCvx module via a 100 m optical cable. The TTCvx provided the 40.00 Mhz clock source for the TTCvi module. Measurements were conducted while repeatedly transmitting two broadcast (BC) commands over channel B and L1 Accept over channel A (case 1) and then again without the BC commands / L1 Accepts (case...
متن کاملHigh-Speed Jitter Testing of XFP Transceivers
Jitter is a key performance factor in high-speed digital transmission systems, such as synchronous optical networks/synchronous digital hierarchy (SONET/SDH), optical transport networks (OTN), and 10 Gigabit Ethernet (GE). This paper outlines the differences between telecom and datacom jitter standards and describes the various jitter applications for compliance testing of 10 G small form-facto...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Astronomy and Space Sciences
سال: 2013
ISSN: 2093-5587
DOI: 10.5140/jass.2013.30.3.141