Joining Method of Ceramic/Metal Shaft with High Heat Resistance.
نویسندگان
چکیده
منابع مشابه
THE OXIDATION RESISTANCE OF HIGH ALUMINUM HEAT RESISTANT STEELS
Abstract: In this research, the oxidation behaviour of high Aluminum heat resistant steel (%25Cr,%20Ni,%8Al) hasbeen evaluated at the temperature range of (1000-1300ºC).The results showed that there was no countinous healinglayer on the surface of the alloy when Al increased up to %5.5 and the oxidation resistance of steel decreased due toformation of spinel oxides on the surface.By increasing ...
متن کاملPredicted Fracture Behavior of Shaft Steels with Improved Corrosion Resistance
One of the crucial steps in the shaft design process is the optimal selection of the material. Two types of shaft steels with improved corrosion resistances, 1.4305 and 1.7225, were investigated experimentally and numerically in this paper in order to determine some of the material characteristics important for material selection in the engineering design process. Ultimate tensile strength and ...
متن کاملon the practicality and effectiveness of a personalized eclectic method incorporated into iranian high school efl syllabus
همگام با سرعت در حال رشد خلاقیت و نوآوری های آموزش زبان به ویژه ظهور روش ارتباطی آموزش زبان? بسیاری از مدارس زبان با بازاندیشی آموزش و پرورش خود? برای گنجاندن فعالیت های ارتباطی، وزمینه ی شخصی سازی شده به شیوه های سنتی خود به روز رسانی شده اند. با این حال، مدارس ایرانی در این زمینه آهسته پیش رفته اند. از این رو، هدف عمده ی پژوهش حاضر برداشتن یک گام در پر کردن شکاف بین نظریه های آموزشی نو ظهور و...
15 صفحه اولEffects of Using Multilayers of High Resistance AFRP on Loading Capacity of Reinforced Concrete Beams in Comparison with Low Resistance AFRP Considering EBROG Method
Externally Bonded Reinforcement on Grooves (EBROG) is a new method that has been introduced to postpone or eliminate debonding of FRP sheets from concrete surface in concrete beams strengthened for flexure and increase loading capacity. For strengthening reinforced conceret beams in strructure, use of different types of FRP like: laminate, AFRP, CFRP, and GFRP. By there is some differences bet...
متن کاملInvestigating the Joining of Ni3Al Intermetallic Compound, using Transient Liquid Phase (TLP) Method with Cu Interlayer
In this study, joining of Ni3Al intermetallic compounds using the transient liquid phase (TLP) process with Cu interlayer was investigated. The binding process was carried out in a vacuum furnace at a temperature of 1050 °C for different times of 30, 60, 90 and 120 minutes. The effect of time variation on microstructure and mechanical properties of the joint zone was investigated. The EDS analy...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1993
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.40.465