Joining of carbon fibre-copper composite to metals
نویسندگان
چکیده
منابع مشابه
Carbon Fibre Composite Bone Plates
We compared the mechanical properties of carbon fibre composite bone plates with those of stainless steel and titanium. The composite plates have less stiffness with good fatigue properties. Tissue culture and small animal implantation confirmed the biocompatibility of the material. We also present a preliminary report on the use of the carbon fibre composite plates in 40 forearm fractures. All...
متن کاملJoining of Carbon Fibre Reinforced Plastics for Automotive Applications
The introduction of carbon-fibre reinforced plastics in load bearing automotive structures provides a great potential to reduce vehicle weight and fuel consumption. To enable the manufacture and assembly of composite structural parts, reliable and cost-effective joining technologies must be developed. This thesis addresses several aspects of joining and load introduction in carbon-fibre reinfor...
متن کاملJoining prepreg composite interfaces with aligned carbon nanotubes
1359-835X/$ see front matter 2008 Elsevier Ltd. A doi:10.1016/j.compositesa.2008.03.011 * Corresponding author. Tel.: +1 617 252 1539. E-mail address: [email protected] (B.L. Wardle). An interlaminar reinforcement using aligned carbon nanotubes (CNTs) is demonstrated for prepreg unidirectional carbon tape composites. Aligned CNTs are grown at high temperature and then transferprinted to prepreg at...
متن کاملJoining Ceramics to Metals using Metallic Foam
A general method for brazing ceramics to metals using a compliant metallic foam as a buffer layer has been developed. Using stainless steel foams, bonds between alumina and 316 stainless steel with shear strengths up to 33 MPa have been achieved. The resultant ductility enhances the resistance of the joint to thermal cycling; AlN-Inconel 600 bonds exhibited good thermal shock resistance. Alumin...
متن کاملCompressive response of a 3D non-woven carbon-fibre composite
The compressive response of a three-dimensional (3D) non-interlaced composite comprising three orthogonal sets of carbon fibre tows within an epoxy matrix is analysed. First, the compressive response is measured in three orthogonal directions and the deformation/failure modes analysed by a combination of X-ray tomography and optical microscopy. In contrast to traditional unidirectional and two-...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Materials Processing Technology
سال: 1995
ISSN: 0924-0136
DOI: 10.1016/0924-0136(95)01915-4