Joint modelling in advanced thin-walled beam models

Chapter 3 Models and Finite Elements for Thin-walled Structures

Thin-Walled Tubes

The axial crushing of thin-walled tubes has been the subject of extensive research in the past. The existing kinematic models for predicting crushing behavior of axially loaded thin-walled tubes are systematically reviewed and analyzed. The advantages and limitations of each model are discussed. A new chain link model for circular tubes and square tubes is presented and studied in detail. Unlik...

Thin-Walled Structures

Experimentally determined natural frequencies and modes shapes are presented for an elastically point-supported isotropic plate with attached masses under impulsive loading. These results are compared to frequencies and to modes shapes determined from the Rayleigh–Ritz method and a finite element analysis using COMSOL. Accelerometers mounted at three locations on the plate, provide input for ME...

Thin-Walled Structures

This paper presents a procedure to determine an element-length dependent strain and stress relation until fracture that is suitable for implementation in finite element models. This material relation is obtained experimentally with an optical measuring system. The strain until fracture is calculated from the measured surface displacements. The stress is derived from the measured force and the c...

Matrix Crack Detection in Thin-walled Composite Beam using Genetic Fuzzy System

Since thin-walled composite structures are widely used in structural engineering, damage in such structures is an important issue of research. Matrix cracking is a principal cause of failure in composites. In the present study, a composite matrix cracking model is implemented in a thin-walled hollow circular cantilever beam using an effective stiffness approach. Such structures are used to mode...