Lamination Effect on Al-Mn Alloy During Can Forming
نویسندگان
چکیده
Abstract Fracture behavior of Al-Mn alloy after plastic deformation is studied by electron microscopy. Cracked can mainly caused the lamination Al-Mg plate. Optimized melt treatment main way to solve problem microporosity. Microporosity be eliminated adjusting casting speed and other technological parameters. As a result, during weakened. The rate cracked cans in process reduced subsequently.
منابع مشابه
Superplastic hemispherical Bulge Forming of a Ti-Al-Mn Alloy
Superplastic sheet thermoforming has been identified as a standard processing route for the production of complex shapes, especially in the aerospace industry. Ti-Al-Mn (OT4-1) alloy is currently being used for aero engine components as well as other aerospace applications by forming through a conventional route which is typically cost, labour and equipment intensive. The Ti-Al-Mn alloy (made a...
متن کاملEffect of Thermomagnetic Treatment on Structure and Properties of Cu–Al–Mn Alloy
The paper studies the influence of magnetic field on magnetic and mechanical properties of Cu-Mn-Al alloy under annealing. The comparative analysis of the magnetic field orientation impact on solid solution decomposition processes in a fixed annealing procedure is held using the methods of low-field magnetic susceptibility, specific magnetization, and microhardness test. The paper highlights ch...
متن کاملEffect of heterogeneously distributed pre-existing dispersoids on the recrystallization behavior of a cold-rolled Al-Mn-Fe-Si alloy
a r t i c l e i n f o It is well known that strong concurrent precipitation, mainly located along grain/subgrain boundaries, results in a coarse and elongated grain structure, and unusual sharp P {011} b566N and/or M {113} b110N texture components during annealing of supersaturated AA3xxx-series alloys. In this study, a supersaturated as-cast Al–Mn– Fe–Si alloy was annealed at three temperature...
متن کاملEffect of Annealing in Magnetic Field on Ferromagnetic Nanoparticle Formation in Cu-Al-Mn Alloy with Induced Martensite Transformation
The paper considers the influence of aging of high-temperature phase on subsequent martensitic transformation in Cu-Al-Mn alloy. The morphology of behavior of martensitic transformation as a result of alloy aging under annealing in a constant magnetic field with different sample orientation relatively to the field direction and without field was studied for direct control of the processes of ma...
متن کاملEffect of Al–5Ti–C Master Alloy on the Microstructure and Mechanical Properties of Hypereutectic Al–20%Si Alloy
Al-5Ti-C master alloy was prepared and used to modify hypereutectic Al-20%Si alloy. The microstructure evolution and mechanical properties of hypereutectic Al-20%Si alloy with Al-5Ti-C master alloy additions (0, 0.4, 0.6, 1.0, 1.6 and 2.0 wt%) were investigated. The results show that, Al-5Ti-C master alloy (0.6 wt%, 10 min) can significantly refine both eutectic and primary Si of hypereutectic ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of physics
سال: 2023
ISSN: ['0022-3700', '1747-3721', '0368-3508', '1747-3713']
DOI: https://doi.org/10.1088/1742-6596/2557/1/012081