Large Deformation Elastic-Plastic Analyses of Steel Damper under Cyclic Loading.
نویسندگان
چکیده
منابع مشابه
Dynamic Plastic Deformation of Deepwater Steel Catenary Risers Under Extreme Cyclic Compressive Loading
This paper (SPE 173892) was revised for publication from paper OTC 25335, first presented at the Offshore Technology Conference, Houston, 5–8 May 2014. Original manuscript received for review 20 June 2014. Revised manuscript received for review 27 October 2014. Paper peer approved 4 November 2014. Summary Steel catenary risers (SCRs) on a large-heave-motion vessel are susceptible to compression...
متن کاملNumerical modelling of elastic-plastic deformation at crack tips in composite material under stress wave loading
The paper deals with the elastic-plastic wave propagations in an anisotropic material subjected to impact loading with emphasis on an ideal fibre-reinforced cubic material under two-dimensional plane strain condition. The system of partial differential equations is hyperbolic. Therefore a characteristic-based difference method is proposed to calculate the formation of the plastic zone at the cr...
متن کاملFinite-element Formulations for Problems of Large Elastic-plastic Deformation
Abstract-An Eulerian finite element formulation is presented for problems of large elastic-plastic flow. The method is based on Hill’s variational principle for incremental deformations, and is ideally suited to isotropically hardening Prandtl-Reuss materials. Further, the formulation is given in a manner which allows any conventions finite element program, for “small strain” elastic-plastic an...
متن کاملNonlinear Numerical Analyses of a Fabricated Connection of Concrete-Filled Steel Column to Steel Beam Under Low-Reversed Cyclic Loading
RESEARCH ARTICLE Nonlinear Numerical Analyses of a Fabricated Connection of Concrete-Filled Steel Column to Steel Beam Under Low-Reversed Cyclic Loading Chunyi Cui, Kun Meng, Yan Kong, Yannian Zhang and Wenxin Zuo Department of Civil Engineering, Dalian Maritime University, Dalian 116026, China School of Civil Engineering, Shenyang Jianzhu University, Shenyang 110168, China School of Civil and ...
متن کاملFinite element analysis of elastic-plastic solids under Vickers indentation: surface deformation
Finite element modeling has been used to study the development of surface deformation during indentation with a Vickers indenter. A wide range of materials with different elastic modulus and yield stresses are examined. Results show that in a pyramidal indentation process, for a perfectly plastic material, sinking-in during loading can change to pile-up in unloading. This phenomenon depends on ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 1998
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.64.2612