Laser based optical nondestructive method for evaluating spruce timber strength
نویسندگان
چکیده
منابع مشابه
Laser-flash-photolysis-spectroscopy: a nondestructive method?
Herein, we report the effect of the laser illumination during the diffuse-reflectance laser-flash-photolysis measurements on the morphological and optical properties of TiO2 powders. A grey-blue coloration of the TiO2 nanoparticles has been observed after intense laser illumination. This is explained by the formation of nonreactive trapped electrons accompanied by the release of oxygen atoms fr...
متن کاملLaser ray-tracing method for optical testing.
We have developed a novel laser ray-tracing method to measure aberrations in optical systems. It consists of delivering narrow laser pencils (by a laser scanner), recording the spots that are formed on the image plane (with a CCD camera), and computing the position of each centroid. This approach could be considered an experimental (approximate) implementation of standard numerical ray tracing....
متن کاملUltrasonic indirect method for evaluating clear wood strength and stiffness
Strength and stiffness assessment of timber members in-service is a crucial task in the rehabilitation of a timber structure. Unsatisfactory results given by traditional procedures applied for appraisal of in-service structural timber members are a strong motivation for research on non-destructive techniques (NDT). For assessing strength and stiffness of clear wood zones of structural members a...
متن کاملImproved method for nondestructive measurement of dynamic pollen source strength from transgenic crops using sonic anemometer
Pollen-mediated gene flow from transgenic crops is a concern of the scientific community as well as the general public. Current lack is a nondestructive method to measure dynamic (hourly or shorter time period) source pollen release rate (source strength) from these crops. This paper reports an improved method using Rotorod concentration samplers and sticky slides, together with a fast response...
متن کاملA Nondestructive Electrical Method for Evaluating Mechanical Properties of Al-foam
Al alloy foams of composition Al-3wt.%Si-2%Cu-2%Mg was produced using powder metallurgical method. Mechanical properties of foams having different density were measured using uni-axial compression test and the measured properties such as elastic modulus and strength were compared with those of other existing commercial foams. The newly produced (Al-3%Si-2%Cu-2%Mg alloy) foams showed comparable ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Wood Science = Faipar
سال: 2016
ISSN: 2064-9231,0014-6897
DOI: 10.14602/woodsci.2016.2.57