LASER CLADDING ON ALUMINIUM BASE ALLOYS
نویسندگان
چکیده
منابع مشابه
Laser cladding of copper base alloys onto Al Si7 Mg0.3
Certain copper alloys have proved to be suitable for laser cladding onto aluminium base. By using the blown powder technique with a 1.5 KW C02 laser, clads without cracks or porosity have been produced. The base material has the composition Al Si7 Mg0.3 and the clads are made from alloyed copper with varying contents of Ni, Fe, Si and Al. Aluminium dilution in the clad can be kept lower than 1 ...
متن کاملEFFECT OF PULSE LASER ENERGY DENSITY ON TiC CLADDING OF ALUMINIUM SUBSTRATE
Original scientific paper In this work, TiC cladded layer has been produced by laser scanning over the preplaced TiC powder on aluminium substrate, using a pulse Nd:YAG laser. Depending on the effective energy density at the specimen surface, TiC was deposited or partially dispersed into the melted aluminium at the specimen surface. Microstructure was evaluated using optical microscopy and SEM/...
متن کاملLaser welding of dissimilar aluminium alloys with filler material
Laser welding of dissimilar aluminium alloys with filler material Luís Filipe Amaro Pinto Instituto Superior Técnico – Technical University of Lisbon – Portugal September 2008 Abstract The aluminium alloys are materials with great potential because of its high strength and low weight. However, the welding of dissimilar aluminium alloys is difficult in autogeneous welding, due to these alloys ar...
متن کاملCreep of Aluminium and Aluminium Alloys
This chapter constitutes an introduction to creep and to the creep response of Aluminium and its alloys. Its major goals are: to provide basic information on creep and its mechanisms to give a description of the more extensively used mathematical relations among creep variables (time, stress and temperature) to illustrate the creep response of pure Aluminium and of Al-Mg alloys to provide a syn...
متن کاملMetallography of Aluminium alloys
This lecture aims at providing a survey of the metallographic techniques available for the examination of aluminium and its alloys. The information must be sufficient to be sure that the students and the users are able to choose the most suitable technique to solve their problems in the examination of samples. The lecture should contain a direct understanding of the main problems in the metallo...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Le Journal de Physique IV
سال: 1991
ISSN: 1155-4339
DOI: 10.1051/jp4:1991724