Laser fusion.
نویسندگان
چکیده
منابع مشابه
Development of target fabrication for laser-driven inertial confinement fusion at research center of laser fusion
As the basic conditions for laser inertial confinement fusion (ICF) research, the targets are required to be well specified and elaborately fabricated. Because of the characteristics of the targets, the research and fabrication process is a systematically tough task, which needs fundamental and deep insights into film deposition, mechanical machining, precise measurement and assembly, etc. As a...
متن کاملNew Laser Fusion and Its Gain by Intense Laser
The feasibility of a new approach of laser fusion in plasma without implosion has been proposed and is discussed using an intense laser. The cross section of the nuclear reaction is increased by enhancing the penetrability of nuclei through the Coulomb barrier. In this approach, an intense laser field of more than 100 PW was required to distort the Coulomb barrier to obtain enough penetrability...
متن کاملContributions on Laser Driven Inertial Confinement Fusion
The following modified preprint of a chapter in the forthcoming book by Guillermo Velarde and Natividad Carpintero Santamaria Inertial Confinement Nuclear Fusion: A Historical Approach by its Pioneers with personal comments is presented here as an example about the long years difficult developments towards the aim for producing unlimited, safe and clean nuclear energy in the same way as it is t...
متن کاملA Laser Based Fusion Test Facility
The Fusion Test Facility (FTF) is a high repetition rate ignition facility that would bridge the gap between single shot facilities (such as NIF and LMJ) and a fully functioning laser fusion power plant. It would allow development of science and technologies so that follow-on power plants could have predictable performance. The FTF would need to have enough fusion power, about 100 MW, to rigoro...
متن کاملSection 2 PROGRESS IN LASER FUSION
LLE is presently involved in a series of experiments 'intended to demonstrate the ability of direct-drive laser fusion to ablatively compress microencapsulated deuterium-tritium (DT) fuel to 200 times its liquid density. This campaign has been structured into three parts. The first part was initiated in February 1985 and involved the implosion of glass microballoons filled with various pressure...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Review of Laser Engineering
سال: 1987
ISSN: 0387-0200,1349-6603
DOI: 10.2184/lsj.15.441