LHC Collimators Low Level Control System
نویسندگان
چکیده
منابع مشابه
Feedback Configuration Tools for Lhc Low Level Rf System *
The LHC Low Level RF System (LLRF) is a complex multi-VME crate system which is used to regulate the superconductive cavity gap voltage as well as to lower the impedance as seen by the beam through low latency feedback. This system contains multiple loops with several parameters to be set before the loops can be closed. In this paper, we present a suite of MATLAB based tools developed to perfor...
متن کاملThe Lhc Control System
A new control system for the LHC machine has been developed building on the existing controls infrastructure of the CERN accelerators. While the primary target for this development is the LHC the aim is to deploy this system on the other accelerators at CERN starting with the LHC pre-injectors. All layers of the control system have been redeveloped. In the Front Ends FESA is a new software infr...
متن کاملUpdated Simulation Studies of Damage Limit of Lhc Tertiary Collimators
The tertiary collimators (TCTs) in the LHC, installed in front of the experiments, in standard operation intercept fractions of 10 halo particles. However, they risk to be hit by high-intensity primary beams in case of asynchronous beam dump. TCT damage thresholds were initially inferred from results of destructive tests on a TCT jaw, supported by numerical simulations, assuming simplified impa...
متن کاملComparison of Carbon and Hi-z Primary Collimators for the Lhc Phase Ii Collimation System*
A current issue with the LHC collimation system is single-diffractive, off-energy protons from the primary collimators that pass completely through the secondary collimation system and are absorbed immediately downbeam in the cold magnets of the dispersion suppressor section. Simulations suggest that the high impact rate could result in quenching of these magnets. We have studied replacing the ...
متن کاملCommissioning of the Lhc Low Level Rf System Remote Configuration Tools*
The LHC Low Level RF system (LLRF) is a complex multi-loop system used to regulate the superconductive cavity gap voltage as well as to reduce the impedance presented by RF stations to the beam. The RF system can have a profound impact on the stability of the beam; a mis-configured RF system has the potential of causing longitudinal instabilities, beam diffusion and beam loss. To configure the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Nuclear Science
سال: 2008
ISSN: 0018-9499
DOI: 10.1109/tns.2007.914206