Light reflection from a metal surface with subwavelength cavities
نویسندگان
چکیده
منابع مشابه
Subwavelength light bending by metal slit structures.
We discuss how light can be efficiently bent by nanoscale-width slit waveguides in metals. The discussion is based on accurate numerical solutions of Maxwell's equations. Our results, using a realistic model for silver at optical wavelengths, show that good right-angle bending transmission can be achieved for wavelengths lambda> 600 nm. An approximate stop-band at lower wavelengths also occurs,...
متن کاملBeaming light from a subwavelength aperture.
Light usually diffracts in all directions when it emerges from a subwavelength aperture, which puts a lower limit on the size of features that can be used in photonics. This limitation can be overcome by creating a periodic texture on the exit side of a single aperture in a metal film. The transmitted light emerges from the aperture as a beam with a small angular divergence (approximately +/-3 ...
متن کاملExtraordinary light transmission through opaque thin metal film with subwavelength holes blocked by metal disks.
We observed that when subwavelength-sized holes in an optically opaque metal film are completely covered by opaque metal disks larger than the holes, the light transmission through the holes is not reduced, but rather enhanced. Particularly we report (i) the observation of light transmission through the holes blocked by the metal disks up to 70% larger than the unblocked holes; (ii) the observa...
متن کاملAnomalous light absorption around subwavelength apertures in metal films.
In this Letter, we study the heat dissipated at metal surfaces by the electromagnetic field scattered by isolated subwavelength apertures in metal screens. In contrast to the common belief that the intensity of waves created by local sources should decrease with the distance from the sources, we reveal that the dissipated heat at the surface remains constant over a broad spatial interval. This ...
متن کاملNonreciprocal reflection of a subwavelength hole array.
We present measurements of the wavelength-dependent reflectivity of a subwavelength metal hole array on a glass substrate. We compare the observed resonant structures with those found in transmission and note a nonreciprocity under illumination from the air versus the glass side. This can be used to verify on which interface the surface plasmons are resonantly excited and to estimate the losses...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Physics Letters
سال: 2008
ISSN: 0003-6951,1077-3118
DOI: 10.1063/1.2976161