Loop transfer recovery designs with an unknown input reduced-order observer-based controller
نویسندگان
چکیده
منابع مشابه
Full and reduced-order observer-based controller design for Hroptimization
t In this paper the most general Hz control problem is considered. We derive necessary and sufficient conditions when the infimum is attained by state feedback. We do the same for the measurement feedback case where we derive necessary and sufficient conditions when the infimum is attained by proper dynamic compensators. We also investigate reduced-order compensators if some states are observab...
متن کاملAn Unknown Input Observer for Fault Detection Based on Sliding Mode Observer in Electrical Steering Assist Systems
Steering assist system controls the force transfer behavior of the steering system and improves the steering probability of the vehicle. Moreover, it is an interface between the diver and vehicle. Fault detection in electrical assisted steering systems is a challenging problem due to frequently use of these systems. This paper addresses the fault detection and reconstruction in automotive elect...
متن کاملReduced-order observer design for descriptor systems with unknown inputs
A new method for the design of reduced-order observers for descriptor systems with unknown inputs is presented. The approach is based on the generalized constrained Sylvester equation. Sufficient conditions for the existence of the observer are given.
متن کاملFractional order robust adaptive intelligent controller design for fractional-order chaotic systems with unknown input delay, uncertainty and external disturbances
In this paper, a fractional-order robust adaptive intelligent controller (FRAIC) is designed for a class of chaotic fractional order systems with uncertainty, external disturbances and unknown time-varying input time delay. The time delay is considered both constant and time varying. Due to changes in the equilibrium point, adaptive control is used to update the system's momentary information a...
متن کاملFault-Tolerant Control Allocation: an Unknown Input Observer based approach
This paper focuses on the use of unknown input observers for detection and isolation of actuator and effector faults with control reconfiguration in overactuated systems. The control allocation actively uses input redundancy in order to make relevant faults observable. The case study of an overactuated marine vessel supports theoretical developments.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Robust and Nonlinear Control
سال: 1995
ISSN: 1049-8923,1099-1239
DOI: 10.1002/rnc.4590050704