Low depth, low power carry lookahead adders using threshold logic

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Low depth, low power carry lookahead adders using threshold logic

This paper describes a low power threshold logic-gate based on a capacitive input, charge recycling differential sense amplifier latch. The gate is shown to have low power dissipation and high operating speed, as well as robustness under process, temperature and supply voltage variations. This is followed by the main result, which is the development of a novel, low depth, carry lookahead additi...

متن کامل

A Family of Low Depth, Threshold Logic, Carry Lookahead Adders

The main result of this paper is the development of a low depth carry lookahead addition technique based on threshold logic. The adders designed using this method are shown to have a very low logic depth and therefore reduced area and improved speed over conventional logic implementations.

متن کامل

Low depth carry lookahead addition using charge recycling threshold logic

The main result of this paper is the development of a low depth cany lookahead addition technique based on threshold logic. Two such adders are designed using the recently proposed charge recycling threshold logic gate. The adders are shown to have a very low logic depth, and significantly reduced area and power dissipation compared to other dynamic CMOS implementations.

متن کامل

High Speed Multioutput 128bit Carry- Lookahead Adders Using Domino Logic

Addition is the fundamental operation for any VLSI processors or digital signal processing. In this paper focuses on carry -look ahead adders have done research on the design of high-speed, low-area, or low-power adders. Here domino logic is used for implementation and simulation of 128 bit Carrylook ahead adder based HSPICE Tool. In adder circuits propagation delay is the main drawback. To ove...

متن کامل

Using carry-save adders in low-power multiplier blocks

For a simple multiplier block FIR filter design, we compare the effects on power consumption of using direct versus transposed direct forms, tree versus linear structures and carry-save (CS) versus carry-ripple (CR) adders (for which multiplier block algorithms have been designed). We find that tree structures offer power savings, as expected, as does transposition in general but not always. Se...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Microelectronics Journal

سال: 2002

ISSN: 0026-2692

DOI: 10.1016/s0026-2692(02)00112-x