Low-firing Li2ZnTi3O8 microwave dielectric ceramics with BaCu(B2O5) additive
نویسندگان
چکیده
منابع مشابه
LOW-TEMPERATURE SINTERING AND MICROWAVE DIELECTRIC PROPERTIES OF (Zn0.65Mg0.35)TiO3-CaTiO3 CERAMICS WITH H3BO3 ADDITION
Low-melting H3BO3, acting as sintering aid, was used to reduce the sintering temperature of 5 wt.% CaTiO3-doped (Zn0.65Mg0.35)TiO3 ceramics. The sintering behaviors, microstructures and microwave dielectric properties with different amounts of H3BO3 addition were investigated. The results showed that H3BO3 additive was very effective for lowering the sintering temperature and improving the bulk...
متن کاملHigh frequency dielectric properties of A5B4O15 microwave ceramics
High-frequency dielectric properties of A5B4O15 ~A5Ba, Sr, Mg, Zn, Ca; B5Nb, Ta! dielectric ceramics are studied by means of the microwave cavity technique, a combination of far-infrared reflection and transmission spectroscopy and time-resolved terahertz transmission spectroscopy. Microwave permittivity e8 and Q3 f factor vary, depending on the chemical composition, between 11 and 51, and 2.4 ...
متن کاملDielectric nonlinearity of relaxor ferroelectric ceramics at low ac drives
Dielectric nonlinear response of (PbMg1/3Nb2/3O3)0.9(PbTiO3)0.1 (0.9PMN0.1PT) relaxor ceramics was investigated under different ac drive voltages. It was observed that: (i) the dielectric permittivity is independent on ac field amplitude at high temperatures; (ii) with increasing ac drive, the permittivity maximum increases, and the temperature of the maximum shifts to lower temperature; (iii) ...
متن کاملMicrowave Drilling of Ceramics
The microwave-drilling technique using an open-end coaxial applicator was disclosed recently [1-3]. This paper presents new experimental and theoretical results of microwave-drilling studies in various ceramics, including mullite, alumina, and zirconia. The paper reviews the microwave-drill principles and describes the experimental setup and procedures. Aspects of igniting the microwavedrilling...
متن کاملMicrowave NDE of Ceramics
The objective of this work is to evaluate the potential of microwave techniques for detecting, classifying, and determining the dimensions of inclusions and surface cracks in structural ceramics such as Si3N4. Experimental results that show the feasibility of detecting various types of inclusions and voids in Si3N4 have been obtained, and these results are reviewed. In addition, the question of...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of Materials Science
سال: 2011
ISSN: 0250-4707,0973-7669
DOI: 10.1007/s12034-011-0237-7