Low-loss materials for high Q-factor Bragg reflector resonators
نویسندگان
چکیده
منابع مشابه
High-quality-factor Bragg onion resonators with omnidirectional reflector cladding.
We propose to approximate a spherically symmetric Bragg resonator in an onionlike geometry. We develop a transfer-matrix theory for calculation of the quality factors and analyze the effect of the onion stem on cavity Q factors. We find that it is possible to achieve significant inhibition of spontaneous emission in an onion resonator with omnidirectional cladding layers.
متن کاملCharacterization of Materials and Mode Structure for High-Q Resonators using Bragg Confined Modes
This paper describes the design and mode structure of resonators using Bragg confined modes. We investigate a range of low-loss dielectric materials with aim to maximize the Q-factor. The structure is composed of a hollow dielectric cylinder with the mode confined in the central low-loss region. We illustrate the importance of material permittivity and show it is possible to obtain a better Q-f...
متن کاملHigh-Q Low-Impedance MEMS Resonators
Permission to make digital or hard copies of all or part of this work for personal or classroom use is granted without fee provided that copies are not made or distributed for profit or commercial advantage and that copies bear this notice and the full citation on the first page. To copy otherwise, to republish, to post on servers or to redistribute to lists, requires prior specific permission....
متن کاملMicro-Molded High Q Polymer Resonators for Optical Loss Determination
Replica molding of ultra-high-Q toroidal microresonators can produce polymer microresonators with material-limited quality factors (Q). This was demonstrated previously using polymers which cure thermally. In this work, high Q polymer microresonators were fabricated using the replica molding technique from previously uncharacterized polymers which require either a thermal or UV cure. The qualit...
متن کاملRegenerated distributed Bragg reflector fiber lasers for high-temperature operation.
This Letter presents distributed Bragg reflector (DBR) fiber lasers for high-temperature operation at 750°C. Thermally regenerated fiber gratings were used as the feedback elements to construct an erbium-doped DBR fiber laser. The output power of the fiber laser can reach 1 mW at all operating temperatures. The output power fluctuation tested at 750°C was 1.06% over a period of 7 hours. The the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Physics Letters
سال: 2008
ISSN: 0003-6951,1077-3118
DOI: 10.1063/1.2828025