Low-noise and low power CMOS photoreceptor using split-length MOSFET
نویسندگان
چکیده
منابع مشابه
A W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
متن کاملLow Power Low Noise CMOS Chopper Amplifier
AbstractChopping is a proficient way to reduce the low frequency offset and 1/f noise in amplifiers. In this paper, a low power low noise CMOS chopper amplifier is presented. It is composed of a two stage amplifier. The first stage’s high output impedance and the equivalent Miller capacitance of the second stage constitute together a low pass filter, which reduces the power consumption. The cir...
متن کاملa w-band simultaneously matched power and noise low noise amplifier using cmos 0.13µm
a complete procedure for the design of w-band low noise amplifier in mmic technology is presented. the design is based on a simultaneously power and noise matched technique. for implementing the method, scalable bilateral transistor model parameters should be first extracted. the model is also used for transmission line utilized in the amplifier circuit. in the presented method, input/output ma...
متن کاملLow Noise Low Power Transimpedance Amplifier in 0.18μm Cmos Technology
Low noise and low Power transimpedance amplifiers (TIA) are essential modules for optical sensor based systems. But low power and low noise TIAs are still a challenge for the scientists despite of rapid advances in complementary metal oxide semiconductor (CMOS) technology. This paper proposes a three-stage nested miller compensated (NMC) based design of low noise low power transimpedance amplif...
متن کاملA 1.2 V, CMOS Differential Low Noise Amplifier with Low Noise Low Power for Bluetooth Receiver
Abstract A differential Low-noise Amplifier (DLNA) using 0.13 μm CMOS technology is presented. The amplifier is optimized for Bluetooth Receiver applications operating in the 2.4 2.5 GHz band. The inductive degeneration topology used in the DLNA provides low noise, high gain and a large IIP3. The differential LNA was added a cascade output stage to the Single-ended source degenerated stage. Sim...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Electrical Engineering
سال: 2019
ISSN: 1339-309X
DOI: 10.2478/jee-2019-0081