Low Power CMOS-Based Hall Sensor with Simple Structure Using Double-Sampling Delta-Sigma ADC
نویسندگان
چکیده
منابع مشابه
Design of Low Power Sigma Delta ADC
A Low power discrete time sigma delta ADC consisting of a second order sigma delta modulator and third order Cascaded Integrated Comb (CIC) filter is proposed. The second order modulator is designed to work at a signal band of 20K Hz at an oversampling ratio of 64 with a sampling frequency of 2.56 MHz. It achieves a signal to noise ratio of 85.2dB and a resolution of 14 bits. The CIC digital fi...
متن کاملCMOS Image Sensor using Delta-Sigma Modulation
A CMOS image sensor ADC using delta-sigma modulation is presented and discussed. Experimental results from a test chip are presented. The experimental results show that the proposed ADC has several benefits over the use of pipeline ADCs including noise reduction, fast design times, ease with which to maximize ADC output based on a varying input range, and simple symmetric analog routing for lar...
متن کاملDouble-sampling highpass delta-sigma modulator with inherent frequency translation
A double-sampling highpass delta-sigma modulator (HPDSM) with inherent frequency translation is presented. The switched-capacitor highpass filter with double-sampling not only minimizes the number of capacitors required in the feedback network but also enables chopper stabilization which makes the modulator immune to 1/f noise and DC offset. A first-order prototype HPDSM with 3bit quantization ...
متن کاملDESIGN OF LOW POWER ADC USING 0.18μm CMOS TECHNOLOGY
The dual slope integrating analog to digital converter (ADC) is an efficient one for wireless transmission of ECG signals. Normally the dual slope ADCs are used for high resolution applications and the accuracy is very high. The main advantage of the ADC design is its high speed with low power. The dual slope ADC consists of integrator, comparator and a ten bit binary counter. To design integra...
متن کاملA 3-Bit Pseudo Flash ADC Based Low-Power CMOS Interface Circuit Design for Optical Sensor
The paper presents a CMOS interface circuit design for optical pH measurement that can produce an 8-bit digital output representing the color information (i.e., wavelength, l). In this work we are focusing at reducing the component count by design and hence reducing the cost and silicon area. While it could be further optimized for lower power consumption, the proposed design has been implement...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Sensors
سال: 2020
ISSN: 1424-8220
DOI: 10.3390/s20185285