Low Temperature Synthesis of Spinel Powders by Mechanical Grinding
نویسندگان
چکیده
منابع مشابه
LOW TEMPERATURE SYNTHESIS OF NANOCRYSTALLINE MgAl2O4 SPINEL VIA SUCROSE PROCESS
Abstract: Nanocrystalline MgAl2O4 spinel powder was synthesized using metal nitrates and a polymer matrix-based composed of sucrose and polyvinyl alcohol (PVA). The precursor and the calcined powders were characterized by simultaneous thermal analysis (STA), X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FT-IR), and scanning electron microscopy (SEM). According to XRD res...
متن کاملSynthesis of HfB2 Powders by Carbothermal Reduction
In this research, solid state carbothermal synthesis of HfB2 Nano powders was investigated. For this purpose, HfO2,H3BO3, carbon active or phenolic resin were used as raw materials for carbothermal reaction. After 2-4 hours of milling the raw materials by a planetary ball in an ethanol media, the mixture was heat dried and pressed in to disks under pressure of 20-30 bar. The disks were then pla...
متن کاملTHE EFFECT OF GRINDING TIME ON THE SPECIFIC SURFACE AREA DURING INTENSIVE GRINDING OF MINERAL POWDERS
Abstract: the changes of BET surface area of a mineral substance during intensive grinding process. Validity of the proposedmodel was tested by the experiments performed using a natural chalcopyrite mineral as well as the published data. Itwas shown that the model can predict the experimental results with a very good accuracy and can be used to predictwhat may happen under the similar experimen...
متن کاملZirconia-spinel composites. Part I: synthesis of powders and dense materials
MgAl2O4 and x wt% ZrO2–MgAl2O4 (1 # x # 30) composite powders were prepared by the urea combustion route. The powders were further ground by either ball milling or attrition to refine the grain size. Zirconia was found solely in the tetragonal form. Dense materials were prepared by hot pressing. The spinel matrix grains were submicronic in size. The ZrO2 particles were homogeneously dispersed a...
متن کاملSYNTHESIS OF AL2O3-NI COMPOSITE POWDERS BY CO-PRECIPITATION METHOD
The synthesis of micro-sized, uniformly distributed Al2O3-15Vol% Ni powders were studied through three step co-precipitation of hydroxides mixtures from proper solution, calcination at air atmosphere and final step of calcined powders in a carbon bed. Al and Ni hydroxide and amorphous phase were first obtained from their salt’s solutions through chemical co-precipitation method by adjusti...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Key Engineering Materials
سال: 2004
ISSN: 1662-9795
DOI: 10.4028/www.scientific.net/kem.264-268.53