Low vibration laboratory with a single-stage vibration isolation for microscopy applications
نویسندگان
چکیده
منابع مشابه
Vibration Isolation for Scanning Tunneling Microscopy
Scanning Tunneling Microscopy measures tunneling current from conducting surfaces. Through analysis, it is possible to make a three dimensional picture accurate on an atomic scale of a surface and probe microscopic phenomenon. The procedure is dependent on the distance between the surface of the microscope tip and the sample surface. High tolerances on a scale less than an angstrom are required...
متن کاملA Very Low Temperature Vibration Isolation System
Very low temperature refrigerators are a significant source of low frequency vibrational and acoustic noise, which is a serious challenge to research using high sensitivity mechanical oscillators, or to high resolution scanning tunneling microscopes. We describe the design and operation of a vibration isolation system which is used at very low temperatures. The system consists of four masses su...
متن کاملAdaptive control of a two-stage vibration isolation mount
An adaptive control system has been developed that may be used for active noise and vibration control problems involving one-dimensional propagation. Based on the least-mean-squares (LMS) algorithm, the adaptive controller performs both system identification and control in real time, without the need for a priori measurements of the system. Since the controller is adaptive in nature, it is poss...
متن کاملSingle Network Adaptive Critic for Vibration Isolation Control ?
Vibration isolation control is the critical issue to guarantee the performance of various vibration-sensitive instruments and sensors in practical engineering systems. In this paper, single network adaptive critic (SNAC) based controllers are developed for vibration isolation applications. The SNAC approach differs from the typical action-critic dual network structure in adaptive critic designs...
متن کاملLow-Noise MEMS Vibration Sensor for Geophysical Applications
The need exists for high-sensitivity, low-noise vibration sensors for various applications, such as geophysical data collection, tracking vehicles, intrusion detectors, and underwater pressure gradient detection. In general, these sensors differ from classical accelerometers in that they require no direct current response, but must have a very low noise floor over a required bandwidth. Theory i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Review of Scientific Instruments
سال: 2017
ISSN: 0034-6748,1089-7623
DOI: 10.1063/1.4975832