Luminescence of GaN nanocolumns obtained by photon-assisted anodic etching
نویسندگان
چکیده
منابع مشابه
Fabrication of ordered nanoporous anodic alumina prepatterned by mold-assisted chemical etching
In this article, a simple and cost-effective method to create patterned nanoindentations on Al surface via mold-assisted chemical etching process is demonstrated. This report shows the reaction-diffusion method which formed nanoscale shallow etch pits by the absorption/liberation behaviors of chemical etchant in poly(dimethylsiloxane) stamp. During subsequent anodization, it was possible to obt...
متن کاملSurface Morphology and Formation of Nanostructured Porous GaN by UV-assisted Electrochemical Etching
This article reports on the studies of porous GaN prepared by ultra-violet (UV) assisted electrochemical etching in a solution of 4:1:1 HF: CH3OH:H2O2 under illumination of an UV lamp with 500 W power for 10, 25 and 35 minutes. The optical properties of porous GaN sample were compared to the corresponding as grown GaN. Porosity induced photoluminescence (PL) intensity enhancement was found in t...
متن کاملSynthesis Porous GaN by Using UV-assisted Electrochemical Etching and Its Optical Studies
The PL of porous GaN sample shows higher intensity with smaller FWHM and red-shifting relative to the as-grown sample. The energy gap for porous GaN sample was smaller compare to the as-grown sample. The SEM surface image of UV-assisted electrochemical etching process is shown a shape and size of pore which was formed on the surface of the GaN, therefore the shape of pores formed was in spheric...
متن کاملSelective-Area Growth of Transferable InN Nanocolumns by Using Anodic Aluminum Oxide Nanotemplates
InN nanocolumn arrays were grown on c-plane sapphire with and without anodic aluminum oxide (AAO) nanotemplates. The crystalline quality of InN nanocolumns was significantly improved by selective-area growth (SAG) using AAO templates, as verified by X-ray diffraction measurements. Then, InN nanocolumns were transferred onto p-type silicon substrates after etching off the AAO templates. Current-...
متن کاملGaN Based Nanomaterials Fabrication with Anodic Aluminium Oxide by MOCVD
A highly self-ordered hexagonal array of cylindrical pores has been fabricated by anodizing a thin film of Al on substrate and subsequent growth of GaN and InGaN in these nanoholes has been performed. This AAO templatebased synthesis method provides a low cost process to fabricate GaN-based nanomaterials fabrication.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Physics Letters
سال: 2003
ISSN: 0003-6951,1077-3118
DOI: 10.1063/1.1605231