Machinablity improvement with ultrasonic vibration–assisted micro-milling
نویسندگان
چکیده
منابع مشابه
Laser milling for micro tooling
Laser milling provides a new method of producing components for the micro tool manufacturing industry. This paper considers the technical capabilities of laser milling when applied to the machining of components for micro tooling. Characteristics important for laser milling as a micro tooling manufacturing process are reviewed. These characteristics are surface finish, aspect ratio, dimensional...
متن کاملFabrication of Microfluidic Channel Using Micro End Milling and Micro Electrical Discharge Milling
This paper discusses the fabrication of microfluidic channels using micro end milling and micro electrical discharge (ED) milling on metals and polymers. The width of the microchannels fabricated by micro end milling was 100-800 μm with 1-2 aspect ratio. The average surface roughness values were 100-200 nm and 80-120 nm on metals and polymers respectively. The end milling was found to form more...
متن کاملMicro-Fluidic Channels with Integrated Ultrasonic Transducers
This paper describes the work done in an attempt to integrate ultrasonic sensors in micro-fluidic channels. We have developed a system with fluidic channels having embedded zinc oxide transducers. A zinc oxide film is deposited on a glass substrate and is sandwiched between two electrodes. The transducers made are found to resonate at 400 MHz in thickness mode. The channels are made both from P...
متن کاملMicro Piezoelectric Ultrasonic Motors
This paper reviews recent developments of micro ultrasonic rotary motors using piezoelectric resonant vibrations. Following the historical background, four ultrasonic motors recently developed at Penn State University are introduced; windmill, PZT tube, metal tube, and shear-type motors. Driving principles and motor characteristics are described in comparison with the conventional ultrasonic mo...
متن کاملFuzzy cutting force modelling in micro-milling
Reliable prediction of cutting forces is essential for micromilling. In this paper, a fuzzy cutting force modelling method based on subtractive clustering method filters the noise and estimates the instantaneous cutting forces using observations acquired by sensors during cutting experiments. In the experimental case study, four data sets of micromilling cutting force are used. Each data set is...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Mechanical Engineering
سال: 2018
ISSN: 1687-8140,1687-8140
DOI: 10.1177/1687814018812531