Machining of Carbon Fibre Reinforced Plastics

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Joining of Carbon Fibre Reinforced Plastics for Automotive Applications

The introduction of carbon-fibre reinforced plastics in load bearing automotive structures provides a great potential to reduce vehicle weight and fuel consumption. To enable the manufacture and assembly of composite structural parts, reliable and cost-effective joining technologies must be developed. This thesis addresses several aspects of joining and load introduction in carbon-fibre reinfor...

متن کامل

Some observations in grinding unidirectional carbon fibre-reinforced plastics

This paper investigates the grinding performance of epoxy matrix composites reinforced by unidirectional carbon fibres, using an alumina grinding wheel. Emphasis was placed on understanding the effect of fibre orientations and grinding depths on the grinding force and surface integrity, and on understanding the grinding mechanisms, with a comparison to orthogonal cutting. It was found that grea...

متن کامل

Machining of Fibre Reinforced Plastic Composite Materials

Fibre reinforced plastic composite materials are difficult to machine because of the anisotropy and inhomogeneity characterizing their microstructure and the abrasiveness of their reinforcement components. During machining, very rapid cutting tool wear development is experienced, and surface integrity damage is often produced in the machined parts. An accurate selection of the proper tool and m...

متن کامل

Effect of chisel edge in ultrasonic assisted drilling of carbon fibre reinforced plastics (CFRP)

Ultrasonic assisted drilling (UAD) has been reported effective for thrust force reduction during drilling of CFRP resulting in lower exit delamination. However, this process is not fully understood in relation to machining theory. This work focused on understanding the separate effects of chisel and cutting edges during UAD in comparison with conventional drilling (CD). Experiments were perform...

متن کامل

A study on the grindability of multidirectional carbon fibre-reinforced plastics

This work studied the grindability of the multidirectional carbon fibre-reinforced plastic (CFRP) composites with the panel layup of [(0◦/90◦/45◦/−45◦)3]s. Focuses were on the chip formation, material removal mechanism, ground surface features and grinding force characteristics. The results were systematically compared with the unidirectional CFRP composites. It was found that the grinding forc...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Procedia CIRP

سال: 2014

ISSN: 2212-8271

DOI: 10.1016/j.procir.2014.07.135