Madagascar Sapphire: Low-Temperature Heat Treatment Experiements
نویسندگان
چکیده
منابع مشابه
Low Temperature Specific Heat Enhancement in Fe2VGa
Low-temperature specific heat measurements on the Heusler-type compounds Fe2VGa have been performed. We observed the sample-dependent upturn in C/T at low temperatures which is attributed to the effect of magnetic impurities and/or clusters. After subtracting this extrinsic effect, the resulting γ still indicated heavy fermion behavior with an effective mass of about 20 times larger than the va...
متن کاملLow-temperature heat capacities of synthetic pyrope,
The heat capacities of synthetic pyrope (Mg,Al,Si,O,,), grossular (CasAI,SisO12), and a solid solution pyrope,,grossular,, (Mg,,sCa,,,Al,Si,O,,) have been measured by adiabatic calorimetry in the temperature range l&350 K. The samples were crystallized from glasses in a conventional pistoncylinder apparatus. The molar thermophysical properties at 298.15 K (J mol’ K‘) are: c; So298 % H’h, &P Pyr...
متن کاملLow-temperature heat transfer in nanowires.
A new regime of low-temperature heat transfer in suspended nanowires is predicted. It takes place when (i) only "acoustic" phonon modes of the wire are thermally populated and (ii) phonons are subject to the effective elastic scattering. Qualitatively, the main peculiarities of heat transfer originate due to the appearance of the flexural modes with high density of states in the wire phonon spe...
متن کاملLow-voltage temperature sensor for micro- power harvesters in silicon-on-sapphire CMOS
A low-voltage temperature sensor designed for MEMS power harvesting systems is fabricated. The core of the sensor is a bandgap voltage reference circuit operating with a supply voltage in the range 1–1.5 V. The prototype was fabricated on a conventional 0.5 mm silicon-onsapphire (SOS) process. The sensor design consumes 15 mA of current at 1 V. The internal reference voltage is 550 mV. The temp...
متن کاملEffect of heat treatment of pure and carbon-polluted rhodium samples on the low-temperature resistivity
We present a systematic investigation of conditions for heat treatment of Rh with the aim of increasing the residual resistivity ratio (RRR). The maximal value of RRR for a 25 μm thick foil was found to be 1050 and the optimal treatment conditions were high temperatures, above 1400◦C, and a low pressure of pure oxygen, around 1 μbar. Another batch of foils, containing less magnetic impurities, ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Gems & Gemology
سال: 2019
ISSN: 0016-626X
DOI: 10.5741/gems.55.2.184