Magnet Power Supply for Isabelle

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Stair Current Output Power Supply for Switching Magnet*

The switching magnet for beam distribution is served with Digital Signal Processor (DSP) controlled PWM switching-mode power supply (SMPS). This SMPS is employed phase-shifted parallel (PSP) operation of IGBTs. This technique allows ± 350 A, 2.5 Hz stair output, and ± 350 A at bipolar mode operation. Current feedback and input voltage feed-forward control schemes are applied to improve the outp...

متن کامل

Power Supply and Current Modulation Circuits for Semiconductor Lasers

Design and construction of a stable current supply with protection circuits are described. The reported circuit provides a high-stable and high-level current variable from 0.5-1.2 A with the protect ion circuits to prevent over load current, voltage and off-range temperature operation. A detailed analysis of the circuit parameters is given and the time behaviors of the load voltage/current and ...

متن کامل

Embedded power supply for low-power DSP

The use of dynamically adjustable power supplies as a method to lower power dissipation in DSP is analyzed. Power can be reduced substantially without sacrificing performance in fixed-throughput applications by slowing the clock and lowering supply voltage instead of idling when computational workload varies. This can yield a typical power savings of 30–50%. If latency can be tolerated, bufferi...

متن کامل

Klystron Power Supply for Komac

A switching mode power supply (SMPS) is a hopeful candidate for the 1MW CW klystron power supply of KOMAC (KOrea Multi-purpose Accelerator Complex). The merits of the SMPS are low stored energy, small size, high rating efficiency and possible cost saving whereas the demerits are EMI problem and system complexities. The proposed power is 2MW and it is considered that the modules, each of which h...

متن کامل

Power Quality Improvement in Traction Power Supply Networks

AC railway traction loads are usually huge single phase loads. As a result, a significant amount of Negative Sequence Current (NSC) is injected into utility grid. Moreover, harmonics and consumption ofreactive power are further power quality problems that the supply network is encountering. In this paper, acompensation strategy with the aid of Railway Power Conditioner (RPC) is proposed to over...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: IEEE Transactions on Nuclear Science

سال: 1979

ISSN: 0018-9499

DOI: 10.1109/tns.1979.4330703