Magnetic anisotropy of Nanostructured Fe-Ni-C Coating Produced by Electroless Deposition
نویسندگان
چکیده
The structural and magnetic properties of nanostructured Fe 100-x Ni x -C (0<x<100) coatings produced by electroless plating with different carbohydrates as reducing agents have been investigated. phase-structural state the films was studied diffraction electron microscopy. concentration ranges FCC BCC phases existence in deposited were determined. surface morphology, saturation magnetization, local anisotropy field coercivities are dependent on iron content type agent. correlation between coercivity H c stochastic domain which established magnetometry suggests that magnitude is mainly determined this anisotropy. Keywords: 3d-metal alloys, approach to magnetization law, coercivity.
منابع مشابه
Ni-B Coating Production on Magnesium Alloy by Electroless Deposition
The use of magnesium alloys is limited due to their susceptibility to corrosion although they have many attractive physical and mechanical properties. To increase mechanical and corrosion properties of these alloys, many deposition method and coating types are used. Electroless Ni–B coatings have received considerable interest recently due to its unique properties such as cost-effectiveness, th...
متن کاملNanostructured Iron-nickel Thin Films Synthesized by Electroless Polyol Deposition
FexNi100-x thin films were deposited on conductive (Cu) and non-conductive (Pd activated glass) substrate using an electroless, polyol method. The stoichiometry of film composition, as compared to the precursor concentration, strongly depended on the substrate position. When the substrate was immersed in the refluxing solution, Fe-deficient films were deposited. However Fe-rich films were synth...
متن کاملNanostructured Al–Fe alloys produced by e-beam deposition: static and dynamic tensile properties
Three different aluminum–iron alloys were produced by electron-beam deposition with the iron content in the range 1.15–1.71 at.%. These alloys did not contain any identifiable iron-bearing particles, and exhibited full density with high-angle grain boundaries in the micrometer range, and a sub-grain size typically smaller than 100 nm. The tensile deformation characteristics of the alloys were e...
متن کاملThin films of barium ferrite with perpendicular magnetic anisotropy produced by laser ablation deposition
Barium ferrite thin films with perpendicular magnetic anisotropy have been prepared on heated (001) sapphire substrates by laser ablation deposition in an oxygen atmosphere using a KrF excimer laser. X-ray diffraction patterns reveal highly oriented films of the magnetoplumbite phase with a c-axis angular spread of 1.8”. Scanning electron micrographs reveal that these films are polycrystalline ...
متن کاملNi–Mn–Ga thin films produced by pulsed laser deposition
Polycrystalline Ni–Mn–Ga thin films have been deposited by the pulsed laser deposition ~PLD! technique, using slices of a Ni–Mn–Ga single crystal as targets and onto Si ~100! substrates at temperatures ranging from 673 K up to 973 K. Off-stoichiometry thin films were deposited at a base pressure of 1310 Torr or in a 5 mTorr Ar atmosphere. Samples deposited in vacuum and temperatures above 823 K...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Fizika tverdogo tela
سال: 2023
ISSN: ['0367-3294', '1726-7498']
DOI: https://doi.org/10.21883/pss.2023.06.56090.14h