Martensitic Transformation in SUS304 Steels with the Same Ni Equivalent.
نویسندگان
چکیده
منابع مشابه
Driving force for martensitic transformation in steels
recently determined LVl~ to be 111918 J mol-I at temperatures below 1000 K, and pointed out that their experimental data were free from various 'intercept effects' which had dogged earlier investigations. Similarly, for T<1000K, they deduced '\~s=51.44Jmol-IK-I. There seem to be no data on the variation of LVl~ or ,\~s as a function of x. However, Lobo and Geigerl found that LVll: and ,\S~S do ...
متن کاملMartensitic transformation of individual grains in low-alloyed TRIP steels
E. Jimenez-Melero,* N.H. van Dijk, L. Zhao, J. Sietsma, S.E. Offerman, J.P. Wright and S. van der Zwaag Fundamental Aspects of Materials and Energy, Faculty of Applied Sciences, Delft University of Technology, Mekelweg 15, 2629 JB Delft, The Netherlands Department of Materials Science and Engineering, Delft University of Technology, Mekelweg 2, 2628 CD Delft, The Netherlands European Synchrotro...
متن کاملAnalysis of deformation induced martensitic transformation in stainless steels
Many studies monitoring the formation of martensite during the tensile deformation of austenite report data which are, in principle, affected by both the applied stress and the resulting plastic strain. It is not clear in these circumstances whether the transformation is stress induced (i.e. the stress provides a mechanical driving force) or whether the generation of defects during deformation ...
متن کاملStress-Assisted Isothermal Martensitic Transformation Application to TRIP Steels
Low-temperature plastic flow in TRIP steels has been found to be controlled by stress-assisted isothermal martensitic transformation. For these conditions, the thermodynamics and kinetic theory of martensitic transformations leads directly to constitutive relations predicting the dependence of flow stress on temperature, strain, strain-rate, and stress-state, consistent with the observed behavi...
متن کاملMartensitic Transformation in Microcrystalline Melt-Quenched Fe-Ni Alloys
The features of martensite transformation in Fe (31 32)% Ni melt-quenched alloys are considered. The meltquenching was realized by spinning technique with variable parameters. The influence of the melt-quenching on structural and kinetics transformation parameters is revealed. In particular Ms point is shown to decrease but volume percentage of athermal martensite is found to be invariable with...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Magnetics Society of Japan
سال: 2003
ISSN: 0285-0192
DOI: 10.3379/jmsjmag.27.607