Mass Transfer in Reactors
نویسندگان
چکیده
منابع مشابه
Hydrodynamics and mass transfer inthree-phase airlift reactors for activated Carbon and sludge filtration
A bioreactor refers to any manufactured or engineered device that supports a biologically active environment. These kinds of reactors are designed to treat wastewater treatment. Volumetric mass transfer coefficient and the effect of superficial gas velocity, as the most important operational factor on hydrodynamics, in three-phase airlift reactors are investigated in this study. The experiments...
متن کاملMass Transfer Studies in Shallow Bubble Column Reactors
Mass transfer studies are carried out in a bubble column with an internal diameter of 14 cm and various static liquid heights. The mass transfer coefficient is evaluated by using an oxygen sorption method. A model considering the gas holdup flushing and the sensor response is used. The interfacial mass transfer area is determined according to the measured bubble size distribution. The liquid-si...
متن کاملNumerical Investigation of Turbulent Mass Transfer in a 90° Bend
This paper presents a numerical study of local mass transfer coefficients in a 90° bend using the RNG version of k–e model to include the influence of curvature on the turbulent transport. Simulations were performed for flow through a 90°, 3-D bend for Reynolds numbers of 13500, 90000, and 390000, Schmidt numbers of 2.53 and 700 and curvature ratios of 1.5, 2, and 2.5. The differences betwe...
متن کاملHeat and Mass Transfer in Leather Drying Process
Leather manufacturing involves a crucial energy-intensive drying stage in the finishing process to remove its residual moisture. Determining drying characteristics of leather is vitally important so as to optimize the drying stage. This paper describes an analytical way for determination of the drying characteristics of leather. The model presented, is based on fundamental heat and mass tra...
متن کاملFlow Analysis Heat and Mass Transfer in a Room
This reports the study on the flow behaviour, heat transfer and contamination distribution in a room. For this purpose the 3-D incompressible Navier-Stokes equations, energy equation and a mass transfer equation which model the concentration of contamination have been applied. For turbulence simulation the two equation standard k- turbulence model was employed. By means of SIMPLE algorithm the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of the Society of Chemical Industry, Japan
سال: 1961
ISSN: 0023-2734,2185-0860
DOI: 10.1246/nikkashi1898.64.10_1713