Mass Transfer Rate between Bubble and Emulsion Phase in Fluid Bed
نویسندگان
چکیده
منابع مشابه
Solid Exchange between the Bubble Wake and the Emulsion Phase in a Gas-fluidised Bed
Solid exchange between the bubble wake and the emulsion phase in a gas-fluidised bed was studied both experimentally and theoretically. Measurements were made on the tracer particle concentration profile produced after a single bubble passage in a two-dimensional bed, and the solid exchange coefficients were estimated with the results of simultaneous measurements on the shape, the size and the ...
متن کاملMulti-fluid model applied to calculate backmixing and mass transfer in bubble columns
For the calculation of reactive flows in bubble columns the local interfacial area is one of the key parameters. In addition backmixing causes a residence time distribution in the gas and liquid phase, thus mixing phenomena have to be considered as well. The three-dimensional, instationary flow fields in bubble columns are numerically calculated using an Euler multi-fluid model. The resulting s...
متن کاملLiquid mixing and gas–liquid mass transfer in a three-phase inverse turbulent bed reactor
In this research work, hydrodynamic characteristics and gas–liquid mass transfer in a laboratory scale inverse turbulent bed reactor were studied. In order to characterize internal flow in the reactor, the residence time distribution (RTD) was obtained by the stimulus-response technique using potassium chloride as a tracer. Different solid hold-up (0–0.37) and air superficial velocity (2.7–6.5 ...
متن کاملPropionic acid extraction in a microfluidic system: simultaneous effects of channel diameter and fluid flow rate on the flow regime and mass transfer
In this work, extraction of propionic acid from the aqueous phase to the organic phase (1-octanol) was performed in T-junction microchannels and effects of channel diameter and fluid flow rate on the mass transfer characteristics were investigated. The two-phase flow patterns in studied microchannels with 0.4 and 0.8 mm diameters were observed. Weber number and surface-to-volume ratio were ca...
متن کاملHeat and Mass Transfer in Fixed-bed Tubular Reactor
Heat and mass transfer problem in a fixed-bed tubular reactor is one of the major concerns in the chemical engineering. The two dimensional axial plug flow model was used for a water gas shift reactor to compare heat conduction or mass diffusion with convective effect. In the case of fast fluid flow in highly permeable catalyst-bed, convective heat transfer was dominant compared to heat conduct...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Chemical engineering
سال: 1969
ISSN: 0375-9253
DOI: 10.1252/kakoronbunshu1953.33.880