Measurement of Pressure Distribution on a Full Scale Propeller
نویسندگان
چکیده
منابع مشابه
Cavitation Tunnel Tests for Propeller Noise of a Frv and Comparisons with Full-scale Measurements
This study presents the results of cavitation tunnel tests carried out with model propeller of a Fisheries Research Vessel (FRV) and those of noise measurements with its full-scale propeller to validate the low-noise performance of this propeller. The tests involve the simulation of a target wake using a wake screen and the determination of the nature and extent of the observed cavitation behin...
متن کاملWind pressure measurements on full scale flat roofs
A flat roof surface is known to be subjected to unusually high suction associated with a pair of vortices created under diagonally skewed wind. Prediction of the wind load and its influence on the roof system is an important engineering topic but wind tunnel testing of this situation is not easy with a scaled model. Considering the physics of wind flow for the most critical case, a possibility ...
متن کاملMeasurement and prediction of solar radiation distribution in full-scale greenhouse tunnels
Radiative heterogeneity in greenhouses significantly influences crop activity, particularly transpiration and photosynthesis. This is especially true for plastic tunnels, which are the most commonly used greenhouse type in the Mediterranean basin. A computer model was generated for this study based on sun movement, greenhouse geometry, transmittance of the cover and weather conditions. Experime...
متن کاملMeasurement of Stickiness with Pressure Distribution Sensor
We developed and evaluated a device that can be used for the quantitative measurement of stickiness. While a typical pressure distribution sensor can measure a pressing force, it cannot measure a tensile force. We therefore installed a pin array on a sensor, with the pin array applying an offset pressure to the sensor through its weight. We measured the stickiness of natto and baby powder using...
متن کاملCorrelation Strategy for Propeller Excited Pressure Fluctuations
Market demands have lead to a significant improvement of the vibration and comfort level, especially for complex ship types such as RoRo and RoPax ships. The need to optimise the design for efficiency does not allow to spend extra material with the single purpose to keep the vibration levels at the required values. The better strategy is to minimize the exciting forces as such, where the propel...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Naval Architects of Japan
سال: 1990
ISSN: 1884-2070,0514-8499
DOI: 10.2534/jjasnaoe1968.1990.168_65