Measuring and modelling air mass flow rate in the injection stretch blow moulding process
نویسندگان
چکیده
منابع مشابه
Modelling the Heat during the Injection Stretch Blowing Moulding: Infrared Heating and Blowing Modelling
Effects of temperature: initial heating conditions or self heating during the process, are very important during the injection stretch blow moulding (ISBM) process of PET bottles. The mechanical characteristics of the final products, which are mainly controlled by the final thickness and the orientation of the molecular chains, depend strongly on the process temperature. Modelling the heat tran...
متن کاملA Model of the Injection Moulding Process
This paper is concerned with the injection moulding process, in which hot molten plastic is injected under high pressure into a thin cold mould. Assuming that the velocity and temperature profiles across the mould maintain their shape, a simple steady state model to describe the behaviour of a Newtonian fluid during the rilling stage is developed. Various phenomena of the process are examined, ...
متن کاملLattice Boltzmann Modeling of Injection Moulding Process
Polymer injection in moulds with complicated shapes is common in todays industrial problems. A challenge is to optimize the mould design which leads to the most homogeneous filling. Current commercial softwares are able to simulate the process only partially. This paper proposes a preliminary study of the capability of a two-fluid LatticeBoltzmann model to provide a simple and flexible approach...
متن کاملOptimization of Injection Moulding Process Parameters in the Moulding of Low Density Polyethylene (LDPE)
Injection moulding is one of the most popular polymer processing methods due to its high production rate as well as its ability to produce very intricate geometries at very cheaper cost and within few seconds. There are several flaws which occur while producing plastic parts by Injection moulding, like warpage, shrinkage, flash, sink marks etc. Shrinkage is one of the most critical problems whi...
متن کاملconsequence analysis of the leakage, ignition and explosion during high pressure sour gas injection process to the oil reservoir
there is no doubt that human being needs to become integrated with industry and industry needs to be progressed, daily. on the other hand, serious events in industrial units specially in oil industries has been shown that such damages and events are industry related ones. the consequence of such events and damages which resulted in chemical and poisoned explosions and loss of life and property ...
ذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Material Forming
سال: 2015
ISSN: 1960-6206,1960-6214
DOI: 10.1007/s12289-015-1240-0