Mechanical Alloying Effect on Cu-(Ta,Mo) Powder.
نویسندگان
چکیده
منابع مشابه
Behavior of Cu-Cr Powder Mixtures During Mechanical Alloying (TECHNICAL NOTE)
In the present work, the behavior of Cu-Cr powder mixtures during mechanical alloying has been studied. The powder mixtures with 1, 3 and 6 weight percents of Cr in Cu were treated. They were milled in a ball mill with two different speeds of 250 and 500 rpm using equal numbers of 1 and 2 centimeters balls. The weight ratio of balls to powders was 10 to 1 under argon atmosphere. Ethanol was use...
متن کاملEffect of Ni on Amorphization of Ti-Cu-Ni Ternary alloys Prepared by Mechanical alloying
Amorphous alloys has been taken into consideration because of their unique properties and are nominated as the future engineering materials. In this research, the effect of Ni and milling time on amorphization process and thermal stability of Ti50Cu50-xNix(x=10, 15, 25 at%) alloy system were investigated. The evolution of amorphization during milling, thermal stability and subsequent heat treat...
متن کاملInvestigation on Mechanical and Electrical Properties of Cu-Ti Nanocomposite Produced by Mechanical Alloying
In this paper, Cu-Ti nanocomposite synthesized via ball milling of copper-titanium powders in 1, 3, and 6 of weight percentage compounds. The vial speed was 350 rpm and ball to powder weight ratio kept at 15:1 under Argon atmosphere, and the time of milling was 90 h. Obtained powders were studied by scanning electron microscopy (SEM), X-ray diffraction (XRD), and dynamic light scattering (DLS)....
متن کاملMechanical alloying of Cu and Fe induced by severe plastic deformation of a Cu-Fe composite
A filamentary composite elaborated by cold drawing was processed by High Pressure Torsion (HPT). The nanostructure resulting from this severe plastic deformation (SPD) was investigated thanks to scanning electron microscopy, transmission electron microscopy, X-ray diffraction and 3D atom probe. Although the mutual solubility of Cu and Fe is extremely low at room temperature in equilibrium condi...
متن کاملAN INVESTIGATION ON REACTIVE SINTERING OF NANO-CRYSTALLINE TiO2 -Al POWDER PREPARED BY MECHANICAL ALLOYING
In this research an ultra-fine grained composite structure consisting of an intermetallic matrix together with dispersed nano-sized Al2O3 obtained via mechanical activation of TiO2 and Al in a high energy ball mill and sintering of consolidated samples. Phase composition and morphology of the milled and sintered samples were evaluated by XRD and SEM techniques Thermal behavior of the powder sa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1993
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.40.287