Mechanical Modeling of Al-Mg Alloy Open-Cell Foams
نویسندگان
چکیده
منابع مشابه
FRACTIONAL RECRYSTALLIZATION KINETICS IN DIRECTLY COLD ROLLED Al-Mg, Al-Mg-Sc AND Al-Mg-Sc-Zr ALLOY
The evaluation of texture as a function of recrystallization has been characterized for directly cold rolled Al-6Mg, Al-6Mg-0.4Sc and Al-6Mg-0.4Sc-0.2Zr alloys. Samples were annealed isothermally at 400 °C for 1 to 240 minutes to allow recrystallization. Recrystallization kinetics of the alloys is analyzed from the micro-hardness variation. Isothermally annealed samples of aluminum alloys were ...
متن کاملMeasurement and Modeling of Creep in Open-Cell NiAl Foams
Nickel-rich NiAl foams, consisting of open cells with hollow struts and exhibiting two relative densities (5.0 and 6.6 pct) and average cell sizes (1.27 and 0.85 mm), were creep tested between 800 °C and 1100 °C under compressive stresses between 0.10 and 1.50 MPa. For stresses lower than 0.50 MPa, the foams exhibit secondary creep with power-law behavior characterized by creep exponents and ac...
متن کاملInfluence of Rolling Temperature on Microstructure and Mechanical Properties of Cryorolled Al-Mg-Si Alloy
An effect of rolling temperature on the mechanical properties and microstructural evolution of an Al-Mg-Si alloy was studied. The material was rolled up to a true strain of ∼0.7 at three different temperatures viz; room temperature, liquid propanol and liquid nitrogen. The liquid nitrogen rolled sample exhibited superior properties with a yield and tensile strength of 332 MPa and 364 MPa, respe...
متن کاملExperimental Analysis of Microstructure and Mechanical Behaviour in Fine Grained Al-Zn-Mg Alloy
The high strength Al-Zn-Mg alloy is widely used for structure components in critical aerospace applications. Small additions of scandium (Sc) often refine cast microstructure and mechanical properties by forming metastable Al3Sc dispersoids. The main role of the Al3Sc dispersoid is to prevent recrystallization during hot deformation and solution treatment. A new technique to apply for surface m...
متن کاملStudy on Mg/Al Weld Seam Based on Zn–Mg–Al Ternary Alloy
Based on the idea of alloying welding seams, a series of Zn-xAl filler metals was calculated and designed for joining Mg/Al dissimilar metals by gas tungsten arc (GTA) welding. An infrared thermography system was used to measure the temperature of the welding pool during the welding process to investigate the solidification process. It was found that the mechanical properties of the welded join...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2005
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.46.622