Mechanical performance of carbon-glass hybrid composite joints in quasi-static tension and tension-tension fatigue
نویسندگان
چکیده
منابع مشابه
Tension–tension fatigue of hybrid composite rods
The tension–tension fatigue behavior was investigated for a hybrid composite rod comprised of a unidirectional carbon fiber core and a glass fiber shell. Fatigue tests were performed at three R-ratios and four maximum applied stress levels (MAS) while recording the secant modulus at each cycle, and acoustic emission (AE) sensors were employed to monitor the activation of fatigue mechanisms. Fat...
متن کاملExperimental Research of Mechanical Unions Pinned Pre Tension, No Tension and Bonded in Composite Low Module
In recent years the joints mechanically bolted and glued has drawn the attention of the scientific community, the growth of its applications in various sectors of engineering. An advantageous feature of mechanical joints is the low sensitivity to surface preparation, service temperature or humidity. In addition to allowing the removal of a greater number of times without damaging the structure....
متن کاملTension-Tension Fatigue Behavior of Unidirectional C/Sic Ceramic-Matrix Composite at Room Temperature and 800 °C in Air Atmosphere
The tension-tension fatigue behavior of unidirectional C/SiC ceramic-matrix composite at room temperature and 800 °C under air has been investigated. The fatigue hysteresis modulus and fatigue hysteresis loss energy corresponding to different number of applied cycles have been analyzed. The fatigue hysteresis loops models for different interface slip cases have been derived based on the fatigue...
متن کاملMechanical Behavior of BFRP-Steel Composite Plate under Axial Tension
Combining the advantages of basalt fiber-reinforced polymer (BFRP) material and steel material, a novel BFRP-steel composite plate (BSP) is proposed, where a steel plate is sandwiched between two outer BFRP laminates. The main purpose of this research is to investigate the mechanical behavior of the proposed BSP under uniaxial tension and cyclic tension. Four groups of BSP specimens with four d...
متن کاملThe Effect of Tension-tension Fatigue and Lay-up Configuration on Damage Accumulation in Carbon/epoxy Composites
The effect of tension-tension fatigue (T-T) on carbon/epoxy composites (CFC) has been investigated in this paper. Load controlled fatigue tests were conducted in the tension-tension (T-T) cyclic mode with the R-ratio values of 0.1 and 0.3 and subsequently the specimens with the fatigue life over 10 cycles have been studied by means of tensile testing, ultrasonic inspection and quantitative data...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Engineering Failure Analysis
سال: 2020
ISSN: 1350-6307
DOI: 10.1016/j.engfailanal.2020.104730