Mechanical Properties of Zr–Ti–Al–Ni–Cu Bulk Amorphous Sheets Prepared by Squeeze Casting
نویسندگان
چکیده
منابع مشابه
Mechanical properties of La-based bulk amorphous alloy and composites
Influence of different microstructure of La-based fully amorphous samples and its composites on the impact fracture energy were investigated and discussed. Results showed improvement in fracture energy of glassy metals with the presence intermetallic phases, but deteriorated in the presence of dendrite phases and high volume % of crystalline phases.
متن کاملInvestigation of the mechanical properties of various yttria stabilized zirconia based thin films prepared by aqueous tape casting
In this study various yttria doped zirconia based thin films were prepared by the aqueous tape casting method. The rheological property of the paste was studies. The phase content and microstructure of the samples was investigated by X-ray diffraction and scanning electron microscope, respectively. The mechanical properties of thin films were studied by Vickers microhardness and nanoindentatio...
متن کاملStructure and mechanical properties of low stress tetrahedral amorphous carbon films prepared by pulsed laser deposition
Tetrahedral amorphous carbon films have been produced by pulsed laser deposition, at a wavelength of 248 nm, ablating highly oriented pyrolytic graphite at room temperature, in a 10−2 Pa vacuum, at fluences ranging between 0.5 and 35 Jcm−2. Both (100) Si wafers and wafers covered with a SiC polycrystalline interlayer were used as substrates. Film structure was investigated by Raman spectroscopy...
متن کاملcontrol of the optical properties of nanoparticles by laser fields
در این پایان نامه، درهمتنیدگی بین یک سیستم نقطه کوانتومی دوگانه(مولکول نقطه کوانتومی) و میدان مورد مطالعه قرار گرفته است. از آنتروپی ون نیومن به عنوان ابزاری برای بررسی درهمتنیدگی بین اتم و میدان استفاده شده و تاثیر پارامترهای مختلف، نظیر تونل زنی(که توسط تغییر ولتاژ ایجاد می شود)، شدت میدان و نسبت دو گسیل خودبخودی بر رفتار درجه درهمتنیدگی سیستم بررسی شده اشت.با تغییر هر یک از این پارامترها، در...
15 صفحه اولOptimization of Microstructure and Mechanical Properties of Al-A360 Produced by Semi-Solid Casting
Semi-Solid Casting (SSM) is a new process that could produce globular structures with mechanical properties. The cooling slope method (CLM) is a one of this process that was employed to produce the A360 feedstock. In this method, The dendritic primary phase in the conventionally cast A356 alloy has transformed into a non-dendritic one. In this paper, The molten alloy with the temperature (PT) o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Transactions, JIM
سال: 1998
ISSN: 0916-1821,2432-471X
DOI: 10.2320/matertrans1989.39.1230