Mechanical twinning in nickel
نویسندگان
چکیده
منابع مشابه
Significance of mechanical twinning in hexagonal metals at high pressure
Diamond anvil cells (DAC) in radial synchrotron X-ray diffraction geometry were used to investigate texture development and identify deformation mechanisms in zinc and osmium at the Advanced Photon Source (APS) and the Advanced Light Source (ALS), respectively. Further experiments on cadmium and hafnium wires were carried out in the Deformation-DIA (D-DIA) multi-anvil press at APS to study the ...
متن کاملRaney-nickel Catalysts Produced by Mechanical Alloying
Raney catalysts were prepared by a combination of mechanical alloying and leaching as an alternative in the synthesis of Raney-Nickel catalysts. Binary Al-Ni and ternary Al-Ni-Fe alloys with nominal compositions Al65Ni35, Al75Ni25, Al65Ni30Fe5, Al75Ni20Fe5 (in atomic percent), were processed from pure elemental powders; they consisted mainly of the intermetallic B2 AlNi phase. Aluminum was sele...
متن کاملMechanical Properties of Electroformed Nickel Cobalt Alloys
Mechanical properties of nickel-cobalt alloys (0-10% Co) electroformed with low internal stress in sulfamate-based solutions were investigated in as deposited and heat treated conditions. It was demonstrated that alloy properties can be modified by selecting deposition conditions and alloy composition. Recommendations on alloy selection are made based on application requirements. The higher str...
متن کاملMechanical Properties of Copper-Nickel-Titanium Archwires
MECHANICAL PROPERTIES OF COPPER-NICKEL-TITANIUM ORTHODONTIC WIRES Margaret Rosen, D.M.D. Marquette University, 2016 Introduction: The initial phase of orthodontic therapy relies on flexible wires, usually composed of a nickel-titanium alloy, to apply a substantially constant load during tooth movement. Copper has been added to nickel-titanium archwires, resulting in an alloy with potential clin...
متن کاملElectrical and Mechanical Performance of Zirconia-Nickel Functionally Graded Materials
In the present work, six-layered (Zirconia/Nickel) functionally graded materials were fabricated via powder metallurgy technique (PMT). The microstructure, fracture surface and the elemental analysis of the prepared components were studied, and their linear shrinkage, electrical conductivity, fracture toughness and Vickers hardness were evaluated. The results show that the linear shrinkage of t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Metallurgica
سال: 1963
ISSN: 0001-6160
DOI: 10.1016/0001-6160(63)90072-5