Melt volume flow rate and melt flow rate of kenaf fibre reinforced Floreon/magnesium hydroxide biocomposites
نویسندگان
چکیده
منابع مشابه
Melt volume flow rate and melt flow rate of kenaf fibre reinforced Floreon/magnesium hydroxide biocomposites
A study of the melt volume flow rate (MVR) and the melt flow rate (MFR) of kenaf fibre (KF) reinforced Floreon (FLO) and magnesium hydroxide (MH) biocomposites under different temperatures (160-180 °C) and weight loadings (2.16, 5, 10 kg) is presented in this paper. FLO has the lowest values of MFR and MVR. The increment of the melt flow properties (MVR and MFR) has been found for KF or MH inse...
متن کاملFuzzy Modeling of Thermoplastic Composites' Melt Volume Rate
Melt volume-flow rate (MVR) is one of the most important quality indicators of composite materials, which depends on the proportion of the component materials. This paper reports the development of a low complexity fuzzy model that describes the relation between percentage amount of multiwall carbon nanotube (MWCNT), acrylonitrile-butadiene-styrene (ABS), polycarbonate (PC) and MVR of the resul...
متن کاملEffects of Mobile Phone Radiation on Surface Tension and Volume Flow Rate of Human Blood groups
Introduction: The great use of electrical appliances in different life applications is one of the most obvious concerns because of its possible health drawbacks. These investigation reports results of electromagnetic field effect emitted from mobile phones on some biophysical parameters of human blood belonging to blood groups A, B, AB & O collected from the normal persons. The parameters obser...
متن کاملMelt Flow Characterization in Continuous Casting Tundishes
Melt flow in continuous casting tundishes is normal[y characterized by a combined model. The model is used to analyze the residence time disttibution of fluid in a tundish, In this model, the fluid volume in tundish is considered to be consisting of the plug flow, well-mixed flow, and dead volumes. Although this model was proposed over 20 years ago, most researchers have either used it incorrec...
متن کاملPetrography and Metallographic Cooling Rate of H-chondrite Impact Melt
Introduction: Impact melts resulting from craterproducing impacts on asteroids can be used to understand the collisional evolution of our solar system. Part of that analysis includes an assessment of the cooling rates of the impact melts and/or the locations where the melts are deposited. In this study, we examined LAP 04751 [1], which is an impact melt breccia that came from the H-chondrite pa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: SpringerPlus
سال: 2016
ISSN: 2193-1801
DOI: 10.1186/s40064-016-3044-1