Meniscus shape control of molten pure aluminum by electromagnetic force.
نویسندگان
چکیده
منابع مشابه
control of the optical properties of nanoparticles by laser fields
در این پایان نامه، درهمتنیدگی بین یک سیستم نقطه کوانتومی دوگانه(مولکول نقطه کوانتومی) و میدان مورد مطالعه قرار گرفته است. از آنتروپی ون نیومن به عنوان ابزاری برای بررسی درهمتنیدگی بین اتم و میدان استفاده شده و تاثیر پارامترهای مختلف، نظیر تونل زنی(که توسط تغییر ولتاژ ایجاد می شود)، شدت میدان و نسبت دو گسیل خودبخودی بر رفتار درجه درهمتنیدگی سیستم بررسی شده اشت.با تغییر هر یک از این پارامترها، در...
15 صفحه اولan investigation into the morphology of short-time oxide films in molten pure aluminum
aluminum is very sensitive to oxidation reactions. if a fresh surface of melt is exposed to air, it oxidizes quickly and an oxide layer covers the melt surface. new oxide films formed in a very short time during casting are thin and folded. the metal surface can be folded and create a double-oxide film as a result of the melt turbulence. the entrance of this double-oxide film into the melt is o...
متن کاملShape control of near-field probes using dynamic meniscus etching.
Dynamic etching methods for fabricating fibre optic tips are explored and modelled. By vertically translating the fibre during etching by an HF solution under an organic protective layer, a variety of tip shapes were created. The probe taper lengths, cone angles and geometrical probe shapes were measured in order to evaluate the dynamic meniscus etching process. Fibre motion, etching rate, meni...
متن کاملFLOW BEHAVIOR OF MOLTEN METAL IN ALUMINUM LFC PROCESS
The effects of gating system and pattern geometry on the metal flow in the lost foam casting (LFC) process have been investigated using glass covered mold and video recording system. Unlike convectional casting process, the type of the gating system showed little effect on fillability in lost foam, but pattern thickness had large effect on mold filling. The mold filling behavior seems to be con...
متن کاملHigh-pressure Injection Injury with Molten Aluminum
INTRODUCTION A previously healthy 65-year-old male presented to the emergency department complaining of a burn to his right forearm. Just prior to arrival the patient was working at a tool and die company casting products with molten aluminum where he inadvertently caused his injury. Physical examination revealed a burn to the right forearm of varying degrees of severity. A non-painful charred ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1991
ISSN: 0451-5994
DOI: 10.2464/jilm.41.11