METAL FLOW DURING EXTRUSION OF NON-CIRCULAR SECTIONS
نویسندگان
چکیده
منابع مشابه
Optimalization of Die Shap and Flow Lines in Non-Linear Dies in Extrusion of Non-Circular Sections
In this paper, an analytical method for noncircular shape extrusion is presented. Using this method, non-linear deformation field can be described with Hermit cubic spline which is prescribed by the boundary conditions of the die at its entryand exit. The upper bound method has been used to obtain optimum coefficient of the tangential boundary conditions. The results show that the optimum tange...
متن کاملOptimalization of Die Shap and Flow Lines in Non-Linear Dies in Extrusion of Non-Circular Sections
In this paper, an analytical method for noncircular shape extrusion is presented. Using this method, non-linear deformation field can be described with Hermit cubic spline which is prescribed by the boundary conditions of the die at its entryand exit. The upper bound method has been used to obtain optimum coefficient of the tangential boundary conditions. The results show that the optimum tange...
متن کاملFlow Visualization Around a Non - Circular Tube
The flow behavior around a cam shaped tube in cross flow has been investigated experimentally using flow visualization and pressure distribution measurement. The range of attack angle and Reynolds number based on an equivalent circular diameter are within 0 ≤ α ≤ 360˚ and 2 x 104 < Reeq < 3.4 x 104, respectively. The pressure drag features are clarified in relation to the flow behavior around t...
متن کاملSimplified Approach for Torsional Analysis of Non-homogenous Tubes with Non-circular Cross-sections
In this paper a method is presented for torsional analysis of non-homogeneous tubes with arbitrarily shaped cross-sections. A previously presented method based on Bredt’s theory is extended to achieve formulas for torsional analysis. Shear modulus varies through the thickness according to a power law distribution. To validate the accuracy of the presented formulas for angle of twist and shear s...
متن کاملKinematics of metal flow during twist extrusion investigated with a new experimental method
We propose an experimental method for investigating the kinematics of metal flow in twist extrusion (TE). The method is based on a theoretical model of the velocity field. The parameters of this model are determined to satisfy the observed flow-line for characteristic points of the specimen. The model incorporates two physical constraints: (1) metal flow is limited by the surface of the die; (2...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Metallurgica Slovaca
سال: 2014
ISSN: 1338-1156,1335-1532
DOI: 10.12776/ams.v20i1.182