منابع مشابه
Chiral thin films of metal oxide.
In this paper, we describe for the first time the synthesis of new chiral nanosized metal oxide surfaces based on chiral self-assembled monolayers (SAMs) coated with metal oxide (TiO2) nanolayers. In this new type of nanosize chiral surface, the metal oxide nanolayers enable the protection of the chiral self-assembled monolayers while preserving their enantioselective nature. The chiral nature ...
متن کاملUltrathin, ordered oxide films on metal surfaces.
Metal oxides and oxide thin films are extensively used as active catalysts and catalytic supports, as well as in many other important technical applications. Unlike TiO(2), which is a semiconductor and can be investigated using a variety of surface science techniques, most metal oxides are insulators, which seriously restricts their use as model surfaces with modern surface science techniques. ...
متن کاملBridging Tribology and Microrheology of Thin Films
An enhanced version of the flexure-based microgap rheometer (FMR) is described which enables rheological measurements in steady state shearing flows of bulk fluid samples of PDMS with an absolute gap separation between the shearing surfaces of 100 nm – 100 μm. Alignment of the shearing surfaces to a parallelism better then 10 rad allows us to reliably measure shear stresses at shear rates up to...
متن کاملMetal oxide thin films as sensing layers for ozone detection.
In2O3-x thin films with a thickness of 100-990 nm were grown by dc magnetron sputtering. Their structural, electrical and ozone sensing properties were analyzed. Structural investigations carried out by electron probe micro analysis, secondary ion mass spectrometry and atomic force microscopy showed a strong correlation between stoichiometry, surface topology and gas sensitivity. Moreover, the ...
متن کاملZirconium Oxide Mixed Tantalum Oxide High-K Gate Dielectric Films for Metal-Oxide-Semiconductor (MOS) Devices
Hafnium oxide mixed tantalum oxide (HTO) and Zirconium oxide mixed tantalum oxide (ZTO) layers were deposited on chemically cleaned p-Si substrate using RF magnetron sputtering technique. The oxide/Si stacks were annealed in oxygen for 30 minutes at 400 °C as on initial investigation. Both composition and structural properties were absolutely interesting to move further for electrical measureme...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The Surface Finishing Society of Japan
سال: 2014
ISSN: 0915-1869,1884-3409
DOI: 10.4139/sfj.65.573