Metamaterial Impedance Matching Network for Ambient RF-Energy Harvesting Operating at 2.4 GHz and 5 GHz
نویسندگان
چکیده
This paper points out the viability of utilization metamaterial transmission lines as a multifrequency impedance matching network, improving RF-Energy Harvesting systems operating around 2.4 GHz and 5 GHz. Metamaterial introduce additional degrees freedom in line design, providing possibility to match multiple bands. The structure has been designed optimized using ADS simulator input four-diode-bridge rectifier connected an energy management system. proposed Impedance Matching Network (MIMN) fabricated standard PCB technologies tested full operative ambient System obtaining DC output voltage 1.8 V 6.8 mF supercapacitor.
منابع مشابه
Design of impedance matching circuits for RF energy harvesting systems
This paper presents a systematic design methodology for impedance matching circuits of an RF energy harvester to maximize the harvested energy for a range of input power levels with known distribution. Design of input matching networks for RF rectifier differs from those for traditional RF circuits such as low-noise amplifier because the transistors in the RF rectifiers operate in different reg...
متن کاملWide band RF MEMS VCO operating at 10 GHz
this paper presents a wide band RF MEMS VCO operating at 10 GHz. The designed VCO is based on high performances RF MEMS solenoid inductor. We have used HFSS software for design and analysis of different RF MEMS solenoid inductors. Best performances are obtained using SU8 dielectric substrate and copper coil: Qmax= 60.9, L = 2.6 nH at 10 GHz, and SRF= 20.8 GHz. Moreover, we have investigated the...
متن کاملHexagonal Shaped Metamaterial Structure for Bandwidth Improvement at 1.794 Ghz
In this present work, Rectangular Microstrip Patch antenna loaded with symmetrically cut H and hexagonal shaped metamaterial (MTM) is proposed for better improvement in the impedance bandwidth and reduction in the return loss at operating frequency 1.794 GHz. The proposed antenna is designed at a height 3.2 mm from the ground plane. At 1.794 GHz, the bandwidth is increased up to 27 MHz in compa...
متن کاملAll-printed diode operating at 1.6 GHz.
Printed electronics are considered for wireless electronic tags and sensors within the future Internet-of-things (IoT) concept. As a consequence of the low charge carrier mobility of present printable organic and inorganic semiconductors, the operational frequency of printed rectifiers is not high enough to enable direct communication and powering between mobile phones and printed e-tags. Here,...
متن کاملEuropean VLBI Network observations of fourteen GHz - Peaked - Spectrum radio sources at 5 GHz
We present the results of EVN polarization observations of fourteen GHz-Peaked-Spectrum (GPS) radio sources at 5 GHz. These sources were selected from bright GPS source samples and we aimed at finding Compact Symmetric Objects (CSOs). We have obtained full polarization 5 GHz VLBI observations of 14 sources providing information on their source structure and spectral indices. The results show th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Electronics
سال: 2021
ISSN: ['2079-9292']
DOI: https://doi.org/10.3390/electronics10101196