METHOD FOR PREDICTING INTERNAL PRESSURE RESPONSES OF VENTED WALL CAVITY AGAINST FLUCTUATING WIND PRESSURE : Study on pressure drops across wall cavity in pressure equalized wall design (Part 2)
نویسندگان
چکیده
منابع مشابه
Low pressure adsorption of CO2 on multi-wall carbon nanotubes
Volumetric techniques were employed to study the adsorption of CO2 on a purified multi-wall carbon nanotubes (MWNT’s) sample, as a mesoporous material, at isothermal conditions of 288, 293 and 298 K and pressures ranging from 30 to 150 kPa. Langmuir, Freundlich and Sips equations were used to represent the isotherms. Also the parameters of these fitted isotherm models have been determined. The ...
متن کاملIntroducing Padded Wall to Reduce Sloshing Induced Wall Pressure in Water Storage Tanks
Sloshing due to ground motion develops large pressure on the walls of water retaining tanks. This paper evaluates the efficacy of padded walls on the reduction of sloshing effects in rectangular water storage tanks subjected to ground motion. An analytical solution based on velocity potential function is provided to obtain the response of rigid and padded wall tanks in terms of the wave elevat...
متن کاملCorrelations of coronary plaque wall thickness with wall pressure and wall pressure gradient: a representative case study
BACKGROUND There are two major hemodynamic stresses imposed at the blood arterial wall interface by flowing blood: the wall shear stress (WSS) acting tangentially to the wall, and the wall pressure (WP) acting normally to the wall. The role of flow wall shear stress in atherosclerosis progression has been under intensive investigation, while the impact of blood pressure on plaque progression ha...
متن کاملlow pressure adsorption of co2 on multi-wall carbon nanotubes
volumetric techniques were employed to study the adsorption of co2 on a purified multi-wall carbon nanotubes (mwnt’s) sample, as a mesoporous material, at isothermal conditions of 288, 293 and 298 k and pressures ranging from 30 to 150 kpa. langmuir, freundlich and sips equations were used to represent the isotherms. also the parameters of these fitted isotherm models have been determined. the ...
متن کاملFailure pressure of straight pipe with wall-thinning under internal pressure
The failure pressure of pipe with wall-thinning was investigated by using three-dimensional elastic-plastic finite element analyses (FEA). With careful modeling of the pipe and flaw geometry in addition to a proper stress-strain relation of the material, FEA could estimate the precise burst pressure obtained by the tests. FEA was conducted by assuming three kinds of materials: line pipe steel, ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Structural and Construction Engineering (Transactions of AIJ)
سال: 2005
ISSN: 1340-4202,1881-8153
DOI: 10.3130/aijs.70.25_5