Micro gas sensor assembly of tin oxide nano-particles by a capillary micro-molding process
نویسندگان
چکیده
منابع مشابه
Tin oxide micro/nano fibers from electrostatic deposition
SnO2 micro/nano fibers in the rutile structure were synthesized using electrospinning and metallorganic decomposition techniques. Fibers were electrospun using two different precursor solutions, one based on SnCl4 and the other on C22H44O4Sn. The fibers were sintered in air for two hours at 400, 500, 600, 700 and 800oC. SEM, AFM, XRD, XPS and Raman microspectrometry were used to characterize th...
متن کاملFabrication of Polymeric Micro needle Array by Micromachining & Micro molding
Microneedles are expected to have greater demand in biomedical applications like sensing, electroporation & drug delivery in the future and there is need for development of fabrication process which is simple, economical and productive. Present work discusses about fabrication of PDMS (polydimethylsiloxane) micro needle array electrode for bio-potential signal measurement like EEG by micromachi...
متن کاملBrownian motion-magnetophoresis of nano/micro-particles.
A new magnetophoresis method to determine the magnetic susceptibility of single nano/microparticles was developed by applying Brownian motion analysis to determine the size of the particle. This method could measure simultaneously both the magnetophoretic velocity and the radius of the identical single nano/microparticles, which are necessary for the determination of the magnetic susceptibility...
متن کاملMicro/nano Surface Tension Measurement by 2d-capillary Wave Resonance
The analysis of capillary waves in confined microspace by quasi-elastic laser scattering (QELS) method enables surface tension measurements. In contrast to previous works, a simple single-beam-focusing method based on spontaneous capillary wave resonance with its confined size is proposed. The capillary wave resonance has been successfully demonstrated in confined two-dimensional micro surface ...
متن کاملMicro-layered-photolithography for Micro- Fabrication and Micro-molding
A novel process based on the principle of layered photolithography has been proposed and tested for making three-dimensional micro-structures. An experimental setup was designed and built for doing experiments on this micro-fabrication process. An ultraviolet (UV) excimer laser at the wavelength of 248 nm was used as the light source and a single piece of photo-mask carrying a series of two dim...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Society of Japan
سال: 2010
ISSN: 1882-0743,1348-6535
DOI: 10.2109/jcersj2.118.202