Micromachined Probe for High Density Data Storage
نویسندگان
چکیده
منابع مشابه
Track-follow Control for High-density Probe-based Storage Devices
Probe-based data-storage devices are being considered as ultra-high-density, smallform-factor and low-power alternatives to conventional data storage. Ultra-high storage densities of up to 1 Tb/in or more can be achieved by using atomic force microscopy (AFM) techniques to write, read back, and erase data in very thin polymer films. High data rates are achieved by parallel operation of large ar...
متن کاملHigh-density optical data storage
Since the introduction of optical data storage systems in the 1970s, we have observed a stepwise increase in their storage capacity using the same means for resolution improvement as in classical microscopy and optical lithography, namely, a reduction in the source wavelength and an increase in the numerical aperture of the imaging optics. In this paper we briefly address the historical develop...
متن کاملShift-Peristrophic Multiplexing for High Density Holographic Data Storage
Holographic data storage is a promising technology that provides very large data storage capacity, and the multiplexing method plays a significant role in increasing this capacity. Various multiplexing methods have been previously researched. In the present study, we propose a shift-peristrophic multiplexing technique that uses spherical reference waves, and experimentally verify that this meth...
متن کاملCoding tradeoffs for high–density holographic data storage
We present an initial experimental evaluation of coding and signal processing tradeoffs in high–density holographic data storage. Block–based and low–pass modulation codes, predistortion of holographic pages during recording (pre–processing), and conventional equalization (post–processing) are compared using a few recorded holograms. The relative gain in number of stored holograms is obtained b...
متن کاملActuation for Probe-Based Mass Data Storage
This paper describes the development of a micro media actuator (MMA) for probe-based mass data storage. The process is based on dry etching and incorporates a thinned silicon media sled to increase the frequency response of the system. The suspended micro-mechanical media sled moves in x-y (±50 μm) using electrostatic actuation. The system design specification requires actuation of an 8x8 mm ma...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Review of Laser Engineering
سال: 2001
ISSN: 0387-0200,1349-6603
DOI: 10.2184/lsj.29.supplement_s11