Microstructural Characteristics of Nickel Alloy Grade 600 After High-Temperature Thermal Cycle
نویسندگان
چکیده
منابع مشابه
Feeding of High-Nickel Alloy Castings
Feeding of the nickel-based alloys CZ-100, M-35-1, and CW-12MW, as well as of the austenitic stainless steel CN-7M, is investigated, using a combination of casting experiments and simulation. Casting trials are performed at five foundries, to produce a total of 55 plates of varying lengths and radiographic soundness levels. In order to develop the property databases necessary to simulate the ca...
متن کاملMixed Field Personnel Dosimetry, Part I: High Temperature Peak Characteristics of the Reader-annealed Tld-600*
~ The high temperature peaks (TL peaks 6-7) of TLD-600 are known to have higher responses to high LET radiation than to low LET radiation. These high temperature peak characteristics were studied for the automatic readerannealed Harshaw albedo neutron TLD. The high temperature peaks response is linear for neutrons over the dose equivalent range tested (0.05-3 mSv of a 252Cf source moderated by ...
متن کاملCerebral Microstructural Alterations after Radiation Therapy in High-Grade Glioma: A Diffusion Tensor Imaging-Based Study
OBJECTIVE To investigate radiation therapy-induced microstructural damage of white matter in patients with high-grade glioma by diffusion tensor imaging (DTI). METHODS DTI was performed in 18 patients with high-grade glioma (WHO grades III and IV) and 13 healthy controls. DTI images were cross-sectionally aligned for the calculation of baseline fractional anisotropy (FA). Interhemispheric FA ...
متن کاملThe strengthening mechanism of a nickel-based alloy after laser shock processing at high temperatures
We investigated the strengthening mechanism of laser shock processing (LSP) at high temperatures in the K417 nickel-based alloy. Using a laser-induced shock wave, residual compressive stresses and nanocrystals with a length of 30-200 nm and a thickness of 1 μm are produced on the surface of the nickel-based alloy K417. When the K417 alloy is subjected to heat treatment at 900 °C after LSP, most...
متن کاملEffects of Warm Laser Peening on Thermal Stability and High Temperature Mechanical Properties of A356 Alloy
To study the effects of warm laser peening (WLP) on the thermal stability and mechanical properties of A356 alloy, the samples were treated by WLP using a Nd:YAG solid-state laser and temperature control device. The residual stress, micro-hardness and microstructures of samples treated by WLP were observed. The result shows that the temperature significantly affects the strengthening effect of ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Biuletyn Instytutu Spawalnictwa
سال: 2017
ISSN: 0867-583X,2300-1674
DOI: 10.17729/ebis.2017.6/7