Microstructure and CTOD (crack tip opening displacement) of Deposit Weld Metal in 30 mm Thick Plate
نویسندگان
چکیده
منابع مشابه
Crack Tip Constraint for Anisotropic Sheet Metal Plate Subjected to Mode-I Fracture
On the ground of manufacturing, sheet metal parts play a key role as they cover about half of the production processes. Sheet metals are commonly obtained from rolling and forming processes which causes misalignment of micro structure resulting obvious anisotropic characteristics and micro cracks. Presence of micro cracks poses serious attention, when stresses at the tip reach to the critical v...
متن کاملModelling the Evolution of Microstructure in Steel Weld Metal
Physical models for the development of microstructure have the potential of revealing new phenomena and properties. They can also help identify the controlling variables. The ability to model weld metal microstructure relies on a deep understanding of the phase transformation theory governing the changes which occur as the weld solidifies and cools to ambient temperature. Considerable progress ...
متن کاملDisplacement Discontinuity Analysis of the Effects of Various Hydraulic Fracturing Parameters on the Crack Opening Displacement (COD)
The combination of horizontal drilling along with hydraulic fracturing has significantly improved the production of hydrocarbon reservoirs and made it possible to extract the relatively impermeable and uneconomical reservoirs. The production rate of oil and gas wells increases proportional to hydraulic fracture aperture or crack opening displacement (COD). This is an important parameter i...
متن کاملultimate flexural strength of plate girders under the effect of weld crack in flange toe
the plate girders are used in important structural systems. the earlier design of plate girders was restricted to their critical bukling capacity. experimental and theoretical studies show the plate girders with vertical stiffners can carry load over than their critical buckling loads and then in modern design codes is permitted to use post- buckling capacity of them. in this case the out- of- ...
متن کاملDirect evaluation of T " integral from experimentally measured near tip displacement ®eld, for a plate with stably propagating crack
In this paper, a method for quantitatively evaluating the T " integral, directly from the measured near-tip displacement ®eld in laboratory specimens made of metallic materials, is presented for the ®rst time. Following Okada and Atluri (Okada, H., Atluri, S.N., 1999. Further studies on the characteristics of the T " integral: plane stress stable crack propagation in ductile materials. Computat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Korean Journal of Materials Research
سال: 2004
ISSN: 1225-0562
DOI: 10.3740/mrsk.2004.14.9.642